Linearization of RF Frontends for 5G
ثبت نشده
چکیده
Widespread adoption of higher order modulation schemes, larger signal bandwidths and higher operating frequencies, to enable higher data throughput in communication links like 5G, places increasingly tough demands on the frontend. Signal fidelity is often enhanced with linearization. The greater number of RF chains and signal bandwidth in 5G Frontends mean that DPD (Digital PreDistortion) may no longer be the default linearization choice; 5G Frontends will be completely different from their 4G predecessors. The key metrics of Efficiency, Linearity, Bandwidth and Output Power remain, as does the question of how to optimally create the signal with just enough fidelity and power, with a minimum of wasted power. The solution set to that question, however, has never been greater. Amongst other topics, this White Paper, (i) proposes a classification of Linearization schemes, (ii) introduces the hard limiter, (iii) illustrates linearization of an exemplary mmWave PA using non-DPD techniques, and (iv) introduces a class of linearized transmitters that create their signal and linearity from efficiently generated components.
منابع مشابه
Future Reconfigurable Radio Frontends for Cognitive Radio and Software Defined Radio: From Functional Materials to Spectrum Management
Cognitive Radio (CR) and Software Defined Radio (SDR), concepts which were mere proposals to solve the population of services over the past two decades, are now enabled by novel materials and components to offer fully reconfigurable devices. Thus, a convergence of services can be attained within a reduced, or even single RF (Radio Frequency) signal path in the device. A solid design of reconfig...
متن کاملConstructing Receiver Signal Points using Constrained Massive MIMO Arrays
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and are limited to on/off switching of antenna elements and a small number of phases. Severe degradations are typically observed for multi-user MIMO for these si...
متن کامل1–10GHz Inductorless Receiver in 0.13μm CMOS
In this paper, we describe an inductorless wideband radio receiver architecture from 1GHz to 10GHz. Two receiver RF frontends designs are presented and compared: a traditional inductor peaking LNA and mixer (IPLM) and a capacitive peaking LNA and mixer circuit (CPLM). Measurement results indicate that CPLM with the same bandwidth has better linearity, comparable noise figure and uses only 17% m...
متن کاملFPGA Implementation of a Hammerstein Based Digital Predistorter for Linearizing RF Power Amplifiers with Memory Effects
Power amplifiers (PAs) are inherently nonlinear elements and digital predistortion is a highly cost-effective approach to linearize them. Although most existing architectures assume that the PA has a memoryless nonlinearity, memory effects of the PAs in many applications ,such as wideband code-division multiple access (WCDMA) or orthogonal frequency-division multiplexing (OFDM), can no longer b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016