A 0.4V 790μw CMOS low noise amplifier in sub-threshold region at 1.5GHz

نویسندگان

  • Amin Zafarian
  • Iraj Kalali Fard
  • Abbas Golmakani
  • Jalil Shirazi
چکیده

A fully integrated low-noise amplifier (LNA) with 0.4V supply voltage and ultra-low power consumption at 1.5GHz by folded cascode structure is presented. The proposed LNA is designed in a TSMC 0.18 μm CMOS technology, in which the all transistors are biased in sub-threshold region. Through the use of the proposed circuit for the gain enhancement in this structure and using forward body bias technique, a very high figure of merit is achieved, in comparison to the similar structures. The LNA provides a power gain of 14.7bB with a noise figure of 2.9dB while consuming only 790μW dc power. Also, the impedance matching of the input and output circuit in its operating frequency is desirable and in the whole circuit bandwidth, input and output isolation is below -33dB.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

A High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process

This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...

متن کامل

A W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm

A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...

متن کامل

Shaeffer and Lee: a 1.5v, 1.5ghz Cmos Low Noise Amplifier

|A 1.5GHz low noise ampli er, intended for use in a Global Positioning System (GPS) receiver, has been implemented in a standard 0.6 m CMOS process. The ampli er provides a forward gain (S21) of 22dB with a noise gure of only 3.5dB while drawing 30mW from a 1.5V supply. To the authors' knowledge, this represents the lowest noise gure reported to date for a CMOS ampli er operating in this freque...

متن کامل

Analysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance

In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...

متن کامل

A Study on Transimpedance Amplifier in 0.35 μm CMOS Technology

This paper presents a design of the transimpedance amplifier using 0.35μm CMOS technology. In the proposed transimpedance amplifier, feedback resistor RF of conventional transimpedance amplifier has been replaced by NMOS transistor as an active feedback resistor. This circuit operates at 3.3V power supply voltage and for a photocurrent of 0.5μA.The proposed transimpedance amplifier having low n...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013