Finite Element Analysis of Hastelloy C-22hs in End Milling
نویسندگان
چکیده
This paper presents the finite element analysis to study the stress distribution of nickel based superalloy HASTELLOY C-2000 in end milling operation. A commercial finite element software was used to develop modeling and analysis the distribution of stress components in the machined surface after end milling of HASTELLOY C-22HS using coated carbide tools. The friction interaction along the tool-chip interface was modeled with Coulomb friction law. It was found that the stress had lower values under the cut surface and increased gradually near the cutting edge.
منابع مشابه
Modelling and Numerical Simulation of Cutting Stress in End Milling of Titanium Alloy using Carbide Coated Tool
Based on the cutting force theory, the cutting stress in end milling operation was predicted satisfactorily through simulation of using finite element method. The mechanistic force models were introduced in high accuracy force predictions for most applications. The material properties in the simulations were defined based on the cutting force theory, as a function of strain and strain rate wher...
متن کاملEffects of Helix Angle Variations on Stability of Low Immersion Milling
The stability behavior of low immersion helical end milling processes is investigated in this paper. Low radial immersion milling operations involve interrupted cutting which induces chatter vibration under certain cutting conditions. Time Finite Element Analysis (TFEA) is suggested for an approximate solution for delayed differential equations encountered during interrupted milling. An improve...
متن کاملComparing up and Down Milling Modes of End-Milling Using Temporal Finite Element Analysis
Two types of end milling at partial radial immersion are distinguished in this work, namely; up and down end-milling. They are theoretically given comparative study for a three tooth end miller operating at 0.5, 0.75 and 0.8 radial immersions. 0.5 and 0.8 radial immersion conditions are chosen so that analysis covers situations in which repeat and continuous tool engagements occur while 0.75 ra...
متن کاملPprediction of Cutting Forces in Micro-milling Process Using Finite Element Method
This paper presents the prediction of micro-milling forces using the finite element method (FE). An FE model of orthogonal micro-cutting with round cutting edge is developed. The cutting force coefficients are identified from a series of FE simulations at a range of cutting edge radii and chip loads. The identified cutting force coefficients are used to simulate micro-milling forces. The simula...
متن کاملThe Performance of an Hexahedron C* Element in Finite Element Analysis
The performance of an 8-noded hexahedron C1* element in elasticity is investigated. Three translational displacements and their derivatives as strain in each direction are considered as degrees of freedom (d.o.f.’s) at each node. The geometric mapping is enforced using a C0 element with no derivative as nodal d.o.f.’s . The stiffness matrix of the element is also computed using a transformation...
متن کامل