Practical Aspects for Design of Indirect Measurement in Dynamic Systems
نویسندگان
چکیده
In different areas of science and engineering are used different indirect measurement procedures that lead to obtaining the quantity desired. In this paper is described the considerations about indirect measurement system (IMS). Is realized the analysis between direct measurement and indirect measurement, presenting the limitations of the estimator. The IMS are classified under the methodological point of view. Practical considerations for design of IMS in dynamic system are specified, as clock cycle, time of hardware execution and software, size of the memory of data and program, represented for quality; system modelling; error estimations and uncertainty in indi-
منابع مشابه
The Comparison of Direct and Indirect Optimization Techniques in Equilibrium Analysis of Multibody Dynamic Systems
The present paper describes a set of procedures for the solution of nonlinear static-equilibrium problems in the complex multibody mechanical systems. To find the equilibrium position of the system, five optimization techniques are used to minimize the total potential energy of the system. Comparisons are made between these techniques. A computer program is developed to evaluate the equality co...
متن کاملA method for bubble volume measurement under constant flow conditions in gas–liquid two-phase flow
Measuring the volume of a bubble, especially at its detachment, is a basic subject in gas-liquid two-phase flow research. A new indirect method for this measurement under constant flow conditions is presented. An electronic device is designed and constructed based on laser beam intensity. This device calculates the frequency of the bubble formation by measuring the total time of the formation p...
متن کاملاندازهگیری پیچش استاتیکی و دینامیکی محورها- کاربرد ویژه در پایش ارتعاشات پیچشی
Strain gage mounted on the surface of the shafts with specified directions are one of the common methods for measurement of the torsion in shafts. The most critical problem in utilization of this method, particularly in the online monitoring of torsional vibration and instantaneous torque in rotary systems, is due to its signal transfer process. In this paper, a simple, practical and feasible m...
متن کاملDesign of nonlinear parity approach to fault detection and identification based on Takagi-Sugeno fuzzy model and unknown input observer in nonlinear systems
In this study, a novel fault detection scheme is developed for a class of nonlinear system in the presence of sensor noise. A nonlinear Takagi-Sugeno fuzzy model is implemented to create multiple models. While the T-S fuzzy model is used for only the nonlinear distribution matrix of the fault and measurement signals, a larger category of nonlinear systems is considered. Next, a mapping to decou...
متن کاملTheoretical, Scientific and Practical Aspects of the Basic Stages of Cad Cam Designing of Centrifugal Pumps
Many theoretical and practical problems arise at different stages of the design/manufacturing process during development of a pump. The experience obtained in pump development proves that the quality of a pump depends on many factors, which should he satisfied to receive good results. At the same time, the theory of engineering design principles exists, which is applicable to designing various ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2006