Measuring mechanical motion with a single spin

We study theoretically the measurement of a mechanical oscillator using a single two-level system as a detector. In a recent experiment, we used a single electronic spin associated with a nitrogen–vacancy center in diamond to probe the thermal motion of a magnetized cantilever at room temperature (Kolkowitz et al 2012 Science 335 1603). Here, we present a detailed analysis of the sensitivity limits of this technique, as well as the possibility to measure the zero-point motion of the oscillator. Further, we discuss the issue of measurement backaction in sequential measurements and find that although backaction heating can occur, it does not prohibit the detection of zero-point motion. Throughout the paper, we focus on the experimental implementation of a nitrogen–vacancy center coupled to a magnetic cantilever; however, our results are applicable to a wide class of spin–oscillator systems. The implications for the preparation of nonclassical states of a mechanical oscillator are also discussed. 5 Author to whom any correspondence should be addressed. Content from this work may be used under the terms of the Creative Commons Attribution-NonCommercialShareAlike 3.0 licence. Any further distribution of this work must maintain attribution to the author(s) and the title of the work, journal citation and DOI. New Journal of Physics 14 (2012) 125004 1367-2630/12/125004+17$33.00 © IOP Publishing Ltd and Deutsche Physikalische Gesellschaft