High Level Power Estimation
نویسنده
چکیده
High level power estimation is essential for designing complex low-power ICs. However, the lack of flexibility of all previously presented high level power estimation approaches limits their use to small (datapath) parts of ICs. In this paper a more general and flexible high level power estimation approach is presented, based on VHDL simulation. The obtained results are very encouraging.
منابع مشابه
Conduction and Dead-Time Voltage Drops Estimation of Asymmetric Cascaded H-Bridge Converters Utilizing Level-Shifted PWM Scheme
Linear AC power supplies can be replaced by their nonlinear switching counterparts due to the lower voltage drops and higher efficiency and power density of switching-mode inverters. Multilevel cascaded H-bridge (CHB) converters are the preferred inverter structure because of modular configuration, control, and protection. The output voltage quality in CHB converters depends on the number of ou...
متن کاملRTL Power Estimation for Large Designs
The increasing demand for portable electronic devices has led to emphasis on power consumption within the semiconductor industry. As a result, chip designers are now forced to consider the impact of not only speed and area, but also power throughout the entire design process. Power reduction has to be addressed at every design level, like system, RTL, gate and transistor-level where most power ...
متن کاملNonlinear Modelling of Kerman Combined Cycle Power Plant Drum-Boiler and Drum Level control especially in trip conditions
There are various methods of power generation such as combined cycle power plants. There are many variables in a power plant boiler unit, but the most important variables are Pressure and specially drum level that control system should be put it in the safe range. The purpose of this article is, modifying the oscillatory behavior of the drum level of Kerman combined cycle power plant and especi...
متن کاملA New High Frequency Grid Impedance Estimation Technique for the Frequency Range of 2 to150 kHz
Grid impedance estimation is used in many power system applications such as grid connected renewable energy systems and power quality analysis of smart grids. The grid impedance estimation techniques based on signal injection uses Ohm’s law for the estimation. In these methods, one or several signal(s) is (are) injected to Point of Common Coupling (PCC). Then the current through and voltage of ...
متن کاملPOWER AND TIMING MODELLING, OPTIMISATION AND SIMULATION Leakage current aware high-level estimation for VLSI circuits
The ever-growing leakage current of MOSFETs in nanometre technologies is the major concern to high performance and power efficient designs. Dynamic power management via powergating is effective to reduce leakage power, but it introduces power-up current that affects the circuit reliability. The authors present an in-depth study on high-level modelling of power-up current and leakage current in ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1997