A New Algorithm for Reactive Electric Power Measurement
نویسنده
چکیده
In this paper a Walsh function (WF) based new algorithm for reactive power measurement is presented. The proposed algorithm allows the convenient calculating process to obtain a reactive power from the entire instant power signal without time delay between current and voltage signal. To test the validity of the suggested approach the simulation tool has been developed by use of “Matlab 6.5” software environment.
منابع مشابه
A New Algorithm for Optimum Voltage and Reactive Power Control for Minimizing Transmission Lines Losses
Reactive power dispatch for voltage profile modification has been of interest Abstract to powerr utilities. Usually local bus voltages can be altered by changing generator voltages, reactive shunts, ULTC transformers and SVCs. Determination of optimum values for control parameters, however, is not simple for modern power system networks. Heuristic and rather intelligent algorithms have to be so...
متن کاملRcd Rules and Power Systems Observability
Power system state estimation is a process to find the bus voltage magnitudes and phase angles at every bus based on a given measurement set. The state estimation convergency is related to the sufficiency of the measurement set. Observability analysis actually tests this kind of problem and guarantees the state estimation accuracy. A new and useful algorithm is proposed and applied in this pape...
متن کاملA New Optimization Algorithm for Optimal Wind Turbine Location Problem in Constantine City Electric Distribution Network Based Active Power Loss Reduction
The wind turbine has grown out to be one of the most common Renewable Energy Sources (RES) around the world in recent years. This study was intended to position the Wind Turbine (WT) on a wind farm to achieve the highest performance possible in Electric Distribution Network (EDN). In this paper a new optimization algorithm namely Salp Swarm Algorithm (SSA) is applied to solve the problem of opt...
متن کاملA New Procedure for Reactive Power Market Clearing Considering Distributed Energy Resources
Traditionally, conventional generation unit was used to provide ancillary services e.g. reactive power support, and spinning reserve. Nonetheless, with the emergence of highly penetrated distributed energy resources (DERs) systems and considering how beneficial they can be; it appears reasonable to use them as reactive power providers. Therefore, this paper introduces a new procedure for DERs t...
متن کاملA Comparison between SVC and STATCOM in Flicker Mitigation of Electric Arc Furnace using Practical Recorded Data
Electric arc furnace (EAF) is one of the largest loads in electric power systems. It is highly time varying and nonlinear. Its reactive power variations cause voltage fluctuations in nearby system which is known as flicker. On the other hand the nonlinear voltage-current characteristic causes strong voltage and current harmonics in EAF. To this end Flexible AC Transmission Systems (FACTS) techn...
متن کاملThe New Definitions for the Power Terms in Distorted and Unbalanced Conditions and Calculation of these Terms for an Electric Arc Furnace
The rapid increase of non-linear loads in the last three decades has caused electrical quantities such as voltages and currents in 3-phase distribution systems to become distorted waveforms. This paper reviews, explains and discusses some new concepts, definitions and new available theory in the unbalanced and distorted systems. The usefulness of the proposed practical definitions is investigat...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2007