EUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH ORGANISATION EUROPEENNE POUR LA RECHERCHE NUCLEAIRE CERN – PS DIVISION PS/CA/Note 2000-001 ANALYSIS OF DIFFERENT OPTIONS FOR A HIGH INTENSITY PROTON DRIVER FOR NEUTRINO FACTORY
نویسندگان
چکیده
This note reports a number of different layouts for designing a high intensity proton driver. Such a machine should perform beam accumulation and bunch compression in order to achieve the performance needed for the production of neutrino in the context of a Neutrino Factory. The different approaches are described in details as well as the optics of the various lattices. Geneva, Switzerland 14 January 2000
منابع مشابه
EUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH ORGANISATION EUROPEENNE POUR LA RECHERCHE NUCLEAIRE CERN PS DIVISION CERN PS 2001-065(BD) N2 and Xe Gas Scintillation Cross-Section, Spectrum, and Lifetime Measurements from 50 MeV to 26 GeV at the CERN PS and Booster
Beam parameters in CERN’s Proton Synchrotron (PS) accelerator must be controlled (and measured) with tighter precision than ever before to meet the stringent requirements of the Large Hadron Collider (LHC) programme. A non-destructive beam profile measurement system would be a valuable diagnostic tool. To this end, we measured N2 and Xe gas scintillation absolute cross-sections and lifetimes fo...
متن کاملEuropean Organization for Nuclear Research Organisation Europeenne Pour La Recherche Nucleaire Cern - Ps Division
The cooling channel of the CERN reference scenario [1] for a possible neutrino factory [2] requires an approximately 200 m long lattice, which provides solenoidal magnetic fields plus longitudinal electric fields at the same time. The electric real estate field gradient along the structure shall be 2 MV/m at 44 MHz, or 4 MV/m at 88 MHz, respectively. The CERN approach incorporates the solenoids...
متن کاملEuropean Organization for Nuclear Research Cern - Ps Division Cern/ps 2000-026 (pp) Status of Studies for a Neutrino Factory at Cern
There is a strong interest from the physics community for high-quality, high-intensity neutrino beams as produced by a neutrino factory. With the help of other European laboratories, CERN has started a study on some of the many technological challenges of such a facility. Present ideas concerning the proton driver, as well as the muon accelerator complex, are presented and plans for the future ...
متن کاملEUROPEAN ORGANIZATION FOR NUCLEAR RESEARCH PS/AE Note 2001–001 CERN-NUFACT Note 061 Transfer Line Between the Proton Driver Accumulator and Compressor Rings for the CERN Neutrino Factory
This note presents a possible design for the transfer line between the proton driver accumulator and compressor rings of the CERN Neutrino Factory. Based on the layout of the two rings presented in Ref. [1], a possible configuration for the transfer line is studied. The geometry and the optics of such a transport system are discussed in details.
متن کاملEuropean Organisation for Nuclear Research Cern - Ps Division
The paper describes the CERN approach for a proton driver for a Neutrino Factory. Two main layouts are presented: the so-called CERN Reference Scenario, based on a 2.2 GeV linac and an alternative one, based on a 30 GeV synchrotron. Both produce bunches of 1 ns (r.m.s.) and a beam power of 4 MW. Presented at NUFACT'00, Monterey, California, USA 22-26 May 2000 Geneva, Switzerland September 2000 ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2000