Effect of the entrained air and initial droplet velocity on the release height parameter of a Gaussian spray drift model.

نویسندگان

  • C Stainier
  • M F Destain
  • B Schiffers
  • F Lebeau
چکیده

The increased concern about environmental effect of off-target deposits of pesticides use has resulted in the development of numerous spray drift models. Statistical models based on experimental field studies are used to estimate off-target deposits for different sprayers in various environmental conditions. Random-walk and computational fluid dynamics (CFD) models have been used to predict the effect of operational parameters and were extensively validated in wind tunnel. A third group, Gaussian dispersion models have been used for several years for the environmental assessment of the pesticide spray drift, mainly for aerial application. When these models were used for the evaluation of boom sprayer spray drift, their predictions were found unreliable in the short range, were the initial release conditions of the droplets have a significant effect on the spray deposits. For longer ranges, the results were found consistent with the field measurements as the characteristics of the source have a reduced influence on the small droplets drift. Three major parameters must be taken into account in order to define realistic initial conditions of the droplets in a spray drift model: the spray pattern of the nozzle, the boom movements and the effect of entrained air and droplet velocities. To take theses parameters into account in a Gaussian model, the nozzle droplet size distribution measured with a PIV setup to divide the nozzle output into several size classes. The spray deposits of each diameter class was computed for each successive position of the nozzle combining the nozzle spray distribution with drift computed with a Gaussian tilting plume model. The summation of these footprints resulted in the global drift of the nozzle. For increasing droplet size, the release height used in the Gaussian model was decreased from nozzle height to ground level using an experimental law to take into account the effect of entrained air and droplet initial velocity. The experimental law was adjusted on 2 m/s wind tunnel measurements and robustness was evaluated for 1 and 4 m/s.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Evaluation of realtime spray drift using RTDrift Gaussian advection-diffusion model.

A spray drift model was developed to deliver real time information to the pesticide applicator. The sprayer is equipped with sensors to deliver real time measurement of operational parameters as spray pressure, boom height, horizontal boom movements and geolocalization. The spray droplet size spectrum as a function of pressure was characterized using PDI measurements. Wind speed and direction w...

متن کامل

Effects of heat generation/absorption on natural convection of nanofluids over the vertical plate embedded in a porous medium using drift-flux model

In this paper, natural convection heat transfer over a vertical plate in a Darcy porous medium saturated with a nanofluid subject to heat generation/absorption was theoretically studied. The governing partial differential equations were transformed to a set of ordinary differential equations using similarity transformations and solved using finite difference method. The influence of parametric ...

متن کامل

Lattice Boltzmann Simulation of Deformation and Breakup of a Droplet under Gravity Force Using Interparticle Potential Model

Abstract In this paper interparticle potential model of the lattice Boltzmann method (LBM) is used to simulate deformation and breakup of a falling droplet under gravity force. First this model is applied to ensure that the surface tension effect is properly implemented in this model. Two tests have been considered. First, it has been checked an initial square drop in a 2D domain can freely def...

متن کامل

Energy and Second Law of Thermodynamics Analysis of Shower Cooling Tower with Variation in Inlet Air Temperature

A shower cooling tower (SCT) operates without fill because of salt decomposition on the fill that leads to deterioration of conventional cooling tower performance. This study presents a two-dimensional mathematical model for energy and exergy analysis of multi-diameter droplets and air interaction along with the height of the forced draft SCT, to predict the exit condition of water droplet for ...

متن کامل

Role of combustion on droplet transport in pressure-atomized spray flames

The transport of droplets in a pressure-atomized kerosene spray flame was examined using a twocomponent phase Doppler system to measure the droplet size and velocity distributions at several locations within the spray. The effect of combustion on droplet transport was examined by comparing the results to a nonburning spray under similar flow conditions. Directions of motion of droplets are calc...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • Communications in agricultural and applied biological sciences

دوره 71 2 Pt A  شماره 

صفحات  -

تاریخ انتشار 2006