Simulated Moving Bed Form Effects on Real-Time In-Stream Sediment Concentration Measurement with Densitometry

This study evaluated fluctuations in the output signal of a densimeter, an in situ suspended-sediment measurement device based on a very sensitive differential pressure transducer. Although the densimeter produced accurate less than 10% error results in the laboratory for concentrations of 10–1,000 mg/L, there was a much larger fluctuation in the field test output signal. These fluctuations were hypothesized to have originated from fluctuations imparted by movement of bed material on the channel bottom. Measuring root mean square and mean velocities and corresponding pressure differences at locations in front of and behind a bluff body simulated movement of a body/bed form past a sampling point in a quasistatic manner. Position of the bluff body relative to the sample port resulted in differential pressure swings equivalent to 65,000 mg/L sediment concentration. Turbulent structure changed dramatically with position of the bluff body. Thus, pressure densitometry using a differential pressure transducer is likely not a reliable system for measuring sediment concentration under in-stream conditions, particularly near the channel bottom where bed forms and large objects may pass between the