Design and Simulation of CMOS Low Noise Amplifier with Micro Antenna for RF Transceiver System
نویسندگان
چکیده
The objective of this research is to define a methodology for designing presents the simulation and design analysis of fully integrated receiver system for millimeter and microwave applications. A beauty thought of new design of CMOS LNA, filter and micro strip antenna are largely improves the system integration, reduced chip area and save the cost. In this paper, a three different architecture are proposed and analyzed through Agilent ADS tool. We have designed 90nm CMOS LNA at 10-20GHz to integrate with band pass filter and rectangular patch antenna at same frequency.
منابع مشابه
A New Ultra-Wideband Low Noise Amplifier With Continuous Gain Control
This paper presents a new variable gain low noise amplifier (VG-LNA) for ultra-wideband (UWB) applications. The proposed VG-LNA uses a common-source (CS) with a shunt-shunt active feedback as an input stage to realize input matching and partial noise cancelling. An output stage consists of a gain-boosted CS cascode and a gain control circuit that moves the high resonant frequency to higher freq...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملReview on Design and Performance Analysis of Low Power Transceiver Circuit in Wireless Sensor Network
WSN is wireless sensor network which consist of numbers of nodes. Transceiver has main role in WSN node. Transceiver consists of both transmitter as well as receiver. Power amplifier, low noise amplifier, mixer, voltage control oscillator are the main block of Transceiver. Power amplifiers are a key part of RF transmitters. 2.4 GHz RF CMOS power amplifier implemented with SMIC 0.13μm is propose...
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملA High Gain and Forward Body Biastwo-stage Ultra-wideband Low Noise Amplifier with Inductive Feedback in 180 nm CMOS Process
This paper presents a two-stage low-noise ultra-wideband amplifier to obtain high and smooth gain in 180nm CMOS Technology. The proposed structure has two common source stages with inductive feedback. First stage is designed about 3GHz frequency and second stage is designed about 8GHz. In simulation, symmetric inductors of TSMC 0.18um CMOS technology in ADS software is used.Simulations results ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015