Influence of target-to-substrate distance on the properties of AZO films grown by RF magnetron sputtering

نویسندگان

  • S. H. Jeong
  • J. H. Boo
چکیده

Transparent conductive aluminum-doped ZnO (AZO) films were prepared by RF magnetron sputtering on glass substrates with specifically designed ZnO target using high-purity of zinc oxide (99.99%) and aluminum hydroxide (99.99%) powders. Systematic study on dependence of target-to-substrate distance (D ) on structural, electrical and optical properties of the as-grown AZO ts films was mainly investigated in this work. XRD shows that highly preferred AZO crystal in the w001x direction was grown in parallel to the substrate while the D doesnot effected to the peak position of XRD. With decreasing D the growth rate is ts ts increased while the electrical resistivity as well as crystal size in the AZO films is decreased. The XPS data show that zinc has remained with nearly oxidation state and has been attributed to the presence of excess zinc in the films. The OyZn ratio in AZO films was increased with increasing D in the films. The as-grown AZO films have an average transmittance of above 85% at ts the visible region. The optical band gap of the as-grown AZO films was changed from 3.18 to 3.36 eV with D . The resistivity ts of the film deposited under D of 45 mm with 4 wt.% Al(OH) doped ZnO in target was approximately 9.8=10 V cm, y2 ts 3 showing a semiconductor property. 2003 Elsevier B.V. All rights reserved.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Deposition of aluminum-doped zinc oxide films by RF magnetron sputtering and study of their structural, electrical and optical properties

Highly oriented undoped and aluminum-doped ZnO (AZO) films in the (002) direction were prepared by RF magnetron sputtering on glass substrates with specifically designed ZnO targets containing different amounts of Al(OH) powder as doping 3 source. A systematic study of the influence of deposition parameters such as Al(OH) content in the target, the target–substrate 3 distance (D ), deposition t...

متن کامل

Mechanical Properties and Microstructural Evolution of Ta/TaNx Double Layer Thin Films Deposited by Magnetron Sputtering

Crystalline tantalum thin films of about 500nm thickness were deposited on AISI 316L stainless steel substrate using magnetron sputtering. To investigate the nano-mechanical properties of tantalum films, deposition was performed at two temperatures (25°C and 200°C) on TaNx intermediate layer with different N2/Ar flow rate ratio from 0 to 30%. Nano-indentation was performed to obtain the mechani...

متن کامل

The Effect of Substrate on Structural and Electrical Properties of Cu3N Thin Film by DC Reactive Magnetron Sputtering

The aim of this paper is to study the effect of substrate on the Cu3N thin films. At first Cu3N thin films are prepared using DC magnetron sputtering system. Then structural properties, surface roughness, and electrical resistance are studied using X-ray diffraction (XRD), the atomic force microscope (AFM) and four-point probe techniques respectively. Finally, the results are investigated and c...

متن کامل

Effect of Thickness on Properties of Copper Thin Films Growth on Glass by DC Planar Magnetron Sputtering

Copper thin films with nano-scale structure have numerous applications in modern technology.  In this work, Cu thin films with different thicknesses from 50–220 nm have been deposited on glass substrate by DC magnetron sputtering technique at room temperature in pure Ar gas. The sputtering time was considered in 4, 8, 12 and 16 min, respectively. The thickness effect on the structural, mo...

متن کامل

The effect of sputtering RF power on structural, optical and electrical properties of CuO and CuO2 thin films

In this paper, the RF power change effect on the structural, optical and electrical properties of CuO thin films prepared by RF reactive magnetron sputtering deposited on glass substrates are studied. At first, the thin films are prepared at 150, 280, 310 and 340W respectively. Then, the films are characterized by XRD, AFM, Uv-visible and four-point probe analysis respectively. The results show...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2004