Crack Growth and Lifetime of Concrete under Long Time Loading

نویسنده

  • Yuyin Xiang
چکیده

Edge-notched eccentrically compressed fracture specimens made of aggregate of reduced size are loaded in standard creep test frames. Measurements of the time rate of crack mouth opening in notched concrete specimens subjected to constant load of almost one month duration are reported and analyzed. To reveal the size effect, geometrically similar specimens of four sizes in the ratio I :2:4:8 are tested. The results are successfully described by a previously proposed time-dependent generalization of the R-curve model, in which the rate of crack growth is a function of the ratio of the stress intensity factor to the R-curve, and linear aging viscoelastic creep in the bulk of the specimen is treated according to the operator method. Good predictions are also obtained with a simplified method in which the R-curve is replaced by a constant asymptotic value of the critical stress intensity factor and creep is handled in similarity to the effective modulus method, neglecting the history effect. The time curves of crack opening terminate with an infinite slope, indicating the lifetime. The finiteness of the lifetime is not caused by creep, but by time-dependent crack growth, which dominates the final stage of crack opening. The initial stage of crack opening, on the other hand, is dominated by creep. Tests are conducted both for concretes of normal strength of 33.4 MPa (4,847 psi) in compression and relatively high strength of 46.4 MPa (6,442 psi). For the stronger concrete, the lifetimes are found to be longer. An increase of specimen size is found to decrease the lifetime. Since the same type of model was previously shown capable of describing all other known time-dependent fracture phenomena in concrete, a rather general applicability may be expected.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Experimental Analysis of Fracture and Damage Mechanics of Pre-Stressed Concrete Sleepers B70: Part B- Analysis

Initial cracks occur in high strength concrete sleepers for various reasons, such as shrinkage and wrong curing and long lifetime of over 50 years of sleepers. These cracks may lead to complete failure of the structure. In order to more accurately design the sleepers, fracture mechanics (not strength of materials) should be incorporated. In order to achieve this purpose, it is important to fore...

متن کامل

Experimental Investigation of Corrosion Cracking in Reinforced Concrete Beams Containing Nano Wollastonite

Cracking of the concrete cover due to corrosion is defined as the serviceability limit state of reinforced concrete structures. This study evaluated the influence of a mineral admixture i.e. nano wollastonite on corrosion performance and serviceability of reinforced concrete structures by performing an accelerated corrosion test on ten reinforced concrete beams under a sustained load. To do so,...

متن کامل

Effect of Boundary Condition on Pre-Existing Crack Under Fatigue Loading

In this paper, the present investigation has been conducted keeping in mind some of the problems concerning the crack propagation direction and growth under constant loading in an inclined crack geometry. The present studies mainly focused on the development and modifications in the crack growth criterion to account the biaxial, shear loading and number of stress terms. Existing criteria for th...

متن کامل

Subcritical crack growth law and its consequences

For brittle failures, the probability distribution of structural strength and lifetime are known to be Weibullian, in which case the knowledge of the mean and standard deviation suffices to determine the loading or time corresponding to a tolerable failure probability such as 10−6. Unfortunately, this is not so for quasibrittle structures, characterized by material inhomogeneities that are not ...

متن کامل

Mean vs. Life-limiting Fatigue Behavior of a Nickel-based Superalloy

The mean and the life-limiting behavior under fatigue of the nickel-based superalloy, IN100, separated (or converged) as a function of stress level and dwell loading. This behavior was related to the control of the life-limiting behavior by the smallcrack growth regime, producing its much slower response to stress level and dwell-time, relative to the mean-lifetime behavior. The lifetime probab...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2001