Young's Modulus and Internal Damping in a Vibrating Rod
نویسندگان
چکیده
منابع مشابه
Experimental Method for Calculating Young's Modulus of Paper from Elongation Test
Young's modulus from a conventional elongation test of paper is usually underestimated, mainly because slippage occurs between the specimen and the grips during loading. A more accurate Young's modulus is sometimes required for a precise discussion of paper science or the suitable material design of paper. Although the vibrating reed method and the ultrasonic method have both been proposed for ...
متن کاملNon-invasive quantitative reconstruction of tissue elasticity using an iterative forward approach.
A novel iterative approach is presented to estimate Young's modulus in homogeneous soft tissues using vibration sonoelastography. A low-frequency (below 100 Hz) external vibration is applied and three or more consecutive frames of B-scan image data are recorded. The internal vibrational motion of the soft tissue structures is calculated from 2D displacements between pairs of consecutive frames,...
متن کاملThermal (in)stability of type I collagen fibrils.
We measured the Young's modulus at temperatures ranging from 20 to 100 degrees C for a collagen fibril that is taken from a rat's tendon. The hydration change under heating and the damping decrement were measured as well. At physiological temperatures 25 to 45 degrees C, the Young's modulus decreases, which can be interpreted as an instability of the collagen. For temperatures between 45 and 80...
متن کامل2 Atomic Force Acoustic Microscopy
Abbreviations a 1 , a 2 , a 3 , a 4 and A 1 , A 2 , A 3 , A 4 Constants in the shape function y(x) a C Contact radius α Wave number of the flexural waves A Cross-section area of the cantilever b Thickness of the cantilever c P Ratio φ Lat /φ d Y 0 , d X0 Normalized amplitude of the sensor tip in y-and x-direction, respectively δ n , δ L Normal, lateral contact deflection (in the coordinate syst...
متن کاملEffects of Degree of Consolidation and Anisotropic Consolidation Stresses on Shear Modulus and Damping Ratio of Cohesive Soils at Low Strain
During consolidation process of saturated cohesive soil the soil stiffness increases. Increase of the effective stress due to dissipation of excess pore pressure causes additional stiffness of soil mass. This phenomenon has a very important effect on the behavior of saturated cohesive soils during dynamic loading. In the current investigation the changes in maximum shear modulus. Gmax and dampi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2017