The prediction of flanking sound transmission below the critical frequency.

نویسندگان

  • John L Davy
  • Jeffrey P Mahn
  • Catherine Guigou-Carter
  • Michel Villot
چکیده

Although reliable methods exist to predict the apparent sound reduction index of heavy, homogeneous isotopic building constructions, these methods are not appropriate for use with lightweight building constructions which typically have critical frequencies in or above the frequency range of interest. Three main methods have been proposed for extending the prediction of flanking sound transmission to frequencies below the critical frequency. The first method is the direct prediction which draws on a database of measurements of the flanking transmission of individual flanking paths. The second method would be a modification of the method in existing standards. This method requires the calculation of the resonant sound transmission factors. However, most of the approaches proposed to calculate the resonant sound transmission factor work only for the case of single leaf homogeneous isotropic building elements and therefore are not readily applicable to complex building elements. The third method is the measurement or prediction of the resonant radiation efficiency and the airborne diffuse field excited radiation efficiency which includes both the resonant and the non-resonant radiation efficiencies. The third method can currently deal with complex building elements if the radiation efficiencies can be measured or predicted. This paper examines these prediction methods.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Low frequency flanking sound transmission in lightweight buildings

ii iii Preface This thesis it the graduation rapport to obtain the degree of Master of Science degree in Building Engineering with a specialization in structural design, at the Technical University in Delft at the faculty of Civil Engineering. Its contents are the result of nine months of research into the flanking sound transmission of low frequencies in lightweight buildings. Although I thoro...

متن کامل

Prediction of Noise Transmission Loss and Acoustic Comfort Assessment of a Ventilated Window using Statistical Energy Analysis

In this paper, a novel analytical method was developed based on statistical energy analysis framework to evaluate sound transmission loss through ventilated windows. The proposed method was compared to numerical and analytical models available in the literature. Results showed the success and advantage of the proposed model in predicting the acoustic performance of the ventilated window and the...

متن کامل

مقایسه افت انتقال صوت در نانوکامپوزیت اکسید روی در دو حالت معمولی و پوشیده با ژلاتین

Introduction: The aim of the present study was preparing polymeric materials and nanocomposites based on nanoparticles of zinc oxide in normal cases the coated with gelatin and comparing them in terms of sound transmission loss in different frequencies.  Method: This study was an experimental one. The materials used in the current study were included zinc oxide nanoparticles, polymer po...

متن کامل

Investigation of Acoustic Properties of Polymer Nanocomposites regarding Combined Sound Absorption and Insulation Characteristics

Introduction: Nowadays multiple techniques have been developed to noise control. One the most important way is the control based on sound absorption and insulation. The purpose of current study was to improve the acoustic properties of soft polyurethane foam regarding combined sound absorption and insulation characteristics. Materials and Methods: Polyacrylonitrile and polyvinylidine fluoride ...

متن کامل

Estimation of Sound Absorption Behavior of Combined Panels Comprising Kenaf Fibers and Micro-Perforated Plates below 2500 Hertz

Introduction: Natural materials are more efficient and attractive than synthetic materials. In this study, the sound absorption behavior by natural kenaf composite and Micro-Perforated Panel (MPP) at low and medium frequency region was investigated. Material and Methods: Initially, the results of kenaf fibers with a thickness of 10 mm were validated by the Finite Element Method (FEM) based on ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:
  • The Journal of the Acoustical Society of America

دوره 132 4  شماره 

صفحات  -

تاریخ انتشار 2012