The strong influence of internal stresses on the nucleation of a nanosized, deeply undercooled melt at a solid-solid phase interface.
نویسندگان
چکیده
The effect of elastic energy on nucleation and disappearance of a nanometer size intermediate melt (IM) region at a solid-solid (S1S2) phase interface at temperatures 120 K below the melting temperature is studied using a phase-field approach. Results are obtained for broad range of the ratios of S1S2 to solid-melt interface energies, k(E), and widths, k(δ). It is found that internal stresses only slightly promote barrierless IM nucleation but qualitatively alter the system behavior, allowing for the appearance of the IM when k(E) < 2 (thermodynamically impossible without mechanics) and elimination of what we termed the IM-free gap. Remarkably, when mechanics is included within this framework, there is a drastic (16 times for HMX energetic crystals) reduction in the activation energy of IM critical nucleus. After this inclusion, a kinetic nucleation criterion is met, and thermally activated melting occurs under conditions consistent with experiments for HMX, elucidating what had been to date mysterious behavior. Similar effects are expected to occur for other material systems where S1S2 phase transformations via IM take place, including electronic, geological, pharmaceutical, ferroelectric, colloidal, and superhard materials.
منابع مشابه
Short-range Order in Undercooled Melts and Its Impact on the Solidification Behaviour
As suggested by Frank [1] an icosahedral short-range order should be energetically favoured in undercooled metallic melts. Such a short-range order is predicted to influence the energy of the interface between the liquid and a solid nucleus, depending on the structure of the solid phase [2]. This in turn decisively impacts the nucleation behaviour of solid phases from the undercooled melt, and ...
متن کاملبررسی تشکیل ترکیبات بینفلزی در ریختهگری مرکب دوفلزی مس و آلومینیوم
The purpose of this article is to study the formation of intermetallic compounds (IMCs) at the interface of Al/Cu bimetal produced by compound casting of molten Al in solid copper tubes. The mechanism of the intermetallic compounds formations at the interface, the effects of molten aluminum pouring temperature and solid copper tubes preheating tempreture, were investigated on the IMCs type...
متن کاملDendrite Growth Kinetics in Undercooled Melts of Intermetallic Compounds
Solidification needs an undercooling to drive the solidification front. If large undercoolings are achieved, metastable solid materials are solidified from the undercooled melt. Containerless processing provides the conditions to achieve large undercoolings since heterogeneous nucleation on container walls is completely avoided. In the present contribution both electromagnetic and electrostatic...
متن کاملاثر نسبت حجمی مذاب- جامد و سرعت دوران بر فصل مشترک جفت فلزی منیزیم- آلومینیم در ریختهگری گریز از مرکز
In this study, centrifugal casting process was used for producing Al/Mg bimetal. Molten Mg was poured at 700 oC, with 1.5 and 3 melt-to-solid volume ratio (Vm/Vs) into the 450 oC preheated solid Al rotating at 800, 1200, 1600 and 2000 rpm. Castings were kept inside the centrifuged casting machine and cooled down to 150 oC. Investigating the effect of melt-to-solid volume ratio showed that incre...
متن کاملTHEORY, EXPERIMENT AND PRACTICE OF SLAG ATTACK OF REFRACTORIES
Penetration and dissolution mechanisms are reviewed for predominantly single-phase oxide, two phase oxide and oxide-carbon composite refractories by liquid silicate slags. Theoretical models of these processes, as well as static (sessile drop, dipping and crucible) and dynamic (rotating finger and rotary slag) experimental tests, along with their practical limitations are considered. Direct (co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Nano letters
دوره 15 4 شماره
صفحات -
تاریخ انتشار 2015