Low frequency heating and flow driven by the dynamic ergodic divertor in tokamaks
نویسنده
چکیده
The profile and dissipation of the field excited by dynamic ergodic divertor (DED) coils in tokamak plasmas are calculated, and an estimate is made of the poloidal/toroidal velocities driven by this field. The coils are idealized as an inboard sheet current composed of a toroidal sequence of helical line current segments expanded in Fourier series with poloidal/toroidal mode numbers M/N , and mode amplitudes depending on feeding. Numerical calculations with cylindrical and toroidal codes show maxima of field dissipation due to Alfvén wave mode conversion effect taking place at the rational magnetic surfaces where q = M/N . The effects of toroidicity and ion collisions in the dielectric tensor in the upper DED frequency range described (f = 5–10 kHz) are found to be very important in absorption calculations. At the q = 3 resonant magnetic surface typical for DED coil design, it is estimated that ponderomotive forces produced by 20 kW of dissipation can drive local toroidal and poloidal flows of respective orders 8 km s−1 and 10 km s−1 in the TEXTOR tokamak. PACS numbers: 52.65.Kj, 52.65.Tt, 52.35.Bj, 52.55.Fa, 52.55.Rk
منابع مشابه
Effect of heating on the suppression of tearing modes in tokamaks.
The suppression of (neoclassical) tearing modes is of great importance for the success of future fusion reactors like ITER. Electron cyclotron waves can suppress islands, both by driving noninductive current in the island region and by heating the island, causing a perturbation to the Ohmic plasma current. This Letter reports on experiments on the TEXTOR tokamak, investigating the effect of hea...
متن کاملThe Effect of Baffling on Divertor Leakage in Alcator C-Mod
Abstract The effect of divertor baffling on Alcator C-Mod has been investigated using a novel divertor bypass. The bypass allows in situ variations in the leakage conductance between the divertor plenum and the main chamber. The experimental results, supported by simple modeling, suggest that C-Mod operates in a regime where the leakage flux is independent of the leakage conductance. The relati...
متن کاملBenefits and Challenges of the Use of High-Z Plasma Facing Materials in Fusion Devices
The use of high-Z plasma facing components requires intensive research in all areas, i.e. in plasma wall-interaction, in the physics of the confined plasma, diagnostic, and in material development. Only a few present day divertor tokamaks mainly Alcator C-Mod and ASDEX Upgrade gained experience with the refractory metals molybdenum and tungsten, respectively. ASDEX Upgrade was stepwise converte...
متن کاملEffects of Large Aspect Ratios and Fluctuations on Hard X-Ray-Detection in Lower Hybrid Driven Divertor Tokamaks
This Article is brought to you for free and open access by the Electrical & Computer Engineering at ODU Digital Commons. It has been accepted for inclusion in Electrical & Computer Engineering Faculty Publications by an authorized administrator of ODU Digital Commons. For more information, please contact [email protected]. Repository Citation Vahala, Linda L.; Vahala, George; and Bonoli, P...
متن کاملAn Analytical Approach to the Effect of Viscous Dissipation on Shear-Driven Flow between two parallel plates with Constant Heat Flux Boundary Conditions
An investigation has been made to analyze the effects of viscous dissipation on the heat transfer characteristics for both hydro-dynamically and thermally fully developed, laminar shear driven flow between two infinitely long parallel plates, where the upper plate is moving in an axial direction at a constant speed. On the basis of some routine assumptions made in the literature, a close form a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2004