Utility of Assimilating Surface Radiometric Temperature Observations for Evaporative Fraction and Heat Transfer Coefficient Retrieval
نویسندگان
چکیده
Recent advances in land data assimilation have yielded variational smoother techniques designed to solve the surface energy balance based on remote observations of surface radiometric temperature. These approaches have a number of potential advantages over existing diagnostic models, including the ability to make energy flux predictions between observation times and reduced requirements for ancillary parameter estimation. Here, the performance of a recently developed variational smoother approach is examined in detail over a range of vegetative and hydrological conditions in the southern U.S.A. during the middle part of the growing season. Smoother results are compared with flux tower observations and energy balance predictions obtained from the two-source energy balance model (TSM). The variational approach demonstrates promise for flux retrievals at dry and lightly vegetated sites. However, results suggest that the simultaneous retrieval of both evaporative fraction and turbulent transfer coefficients by the variational approach will be difficult for wet and/or heavily vegetated land surfaces. Additional land surface information (e.g. leaf area index (LAI) or the rough specification of evaporative fraction bounds) will be required to ensure robust predictions under such conditions. The single-source nature of the variational approach also hampers the physical interpretation of turbulent transfer coefficient retrievals. Intercomparisons between energy flux predictions from the variational approach and the purely diagnostic TSM demonstrate that the relative accuracy of each approach is contingent on surface conditions and the accuracy with which LAI values required by the TSM can be estimated.
منابع مشابه
Evaluation of Evaporative Cooling for Heat Transfer in the Condenser of Window-Air Conditioners
There is a demand for reduced power consumption in the vapor compression refrigeration cycle. Coefficient of performance of window-air conditioners considerably decreases and power consumption increases under very hot conditions. These problems have encouragecl studies aimed at improving the performance of window-air-conditioners by enhancing the heat transfer rate in the condenser. In this ar...
متن کاملEvaluation of Evaporative Cooling for Heat Transfer in the Condenser of Window-Air Conditioners
There is a demand for reduced power consumption in the vapor compression refrigeration cycle. Coefficient of performance of window-air conditioners considerably decreases and power consumption increases under very hot conditions. These problems have encouragecl studies aimed at improving the performance of window-air-conditioners by enhancing the heat transfer rate in the condenser. In this ar...
متن کاملMHD Three-Dimensional Stagnation-Point Flow and Heat Transfer of a Nanofluid over a Stretching Sheet
In this study, the three-dimensional magnetohydrodynamic (MHD) boundary layer of stagnation-point flow in a nanofluid was investigated. The Navier–Stokes equations were reduced to a set of nonlinear ordinary differential equations using a similarity transform. The similarity equations were solved for three types of nanoparticles: copper, alumina and titania with water as the base fluid, to inve...
متن کاملNumerical study of influence of type of nanoparticles and volume fraction on turbulent heat transfer coefficient and pressure loss inter a tube
The conventional liquids have some limitations regarding the thermal properties. The nanoparticles addition is one of the techniques which can modify them. In this research, heat transfer coefficient (h) and pressure loss (Δp) of various nanofluids containing Al2O3, SiO2 and MgO nanoparticles dispersed in water in an annular tube with constant wall temperature were numerically considered. Accor...
متن کاملInvestigation of Heat Transfer Coefficient Enhancement for CuO/TiO2 Nanocomposite in a Tube Heat Exchanger
In order to improve the efficiency and rate of heat transfer in heat exchangers, various techniques such as increasing the heat transfer coefficient are proposed. This study is devoted to the investigation of heat transfer coefficient variations due to the addition of CuO, TiO2 and CuO/TiO2 nanoparticles into a shell and tube heat exchanger. CuO/TiO2 nanocomposite was synthesized using mechanic...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2005