I.V. admixture contamination rates: traditional practice site versus a class 1000 cleanroom.

نویسندگان

  • Mark Thomas
  • Michael D Sanborn
  • Rick Couldry
چکیده

PURPOSE The contamination rates associated with the preparation of medium-risk i.v. admixtures in a traditional practice site and in a class 1000 cleanroom were compared. METHODS Simulated product media fills served as the samples. Each investigator, a pharmacist and a pharmacy technician, prepared 500 vials and 500 small-volume parenteral (SVP) bags in five separate runs at a traditional practice site and in a cleanroom. United States Pharmacopeia chapter 797 medium-risk compounding procedures were followed, and strict adherence to aseptic technique was employed. Single-strength tryptic soy broth was substituted for the drug and diluent in the admixtures. Positive and negative controls were also prepared and stored for the duration of the study. The pharmacist and technician prepared a total of 4057 samples: 2027 samples (1014 vials and 1013 SVP bags) were prepared in a class 1000 cleanroom, and 2030 (1014 vials and 1016 SVP bags) were prepared at a traditional practice site. RESULTS Contamination rates did not significantly differ between the traditional practice site (0.296%) and the cleanroom environment (0.344%) (p = 1.0). A significant difference in the number of contaminated samples was found between the two investigators (2 of 2057 were contaminated by the pharmacist and 11 of 2000 were contaminated by the technician) (p = 0.012). Contamination rates by the pharmacist (p = 1.0) and technician (p = 1.0) did not significantly differ between sites. CONCLUSION The most important variable affecting microbial contamination of admixtures was the aseptic technique of personnel, not the environment in which the drugs were compounded.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Airborne particle deposition in cleanrooms: Calculation of product contamination and required cleanroom class

This is the third and final article in a series that discusses the deposition of airborne particles onto critical surfaces in cleanrooms. This article explains a method for calculating the amount of particle or microbe-carrying particle deposition onto critical cleanroom surfaces, such as product, and a method for calculating the airborne particle cleanliness class, or airborne microbial concen...

متن کامل

A Low-Cost High-Performance Cleanroom Enclosure - Education, IEEE Transactions on

A conventional laboratory room was converted into a cleanroom for laser microfabrication. These simple techniques resulted in a measured class 100 environment at the surface of the optical table, well beyond the class 1000 design goal. The total conversion costs were approximately 40% the cost of a comparable commercial modular cleanroom, sufficiently inexpensive for the devlopment of microfabr...

متن کامل

Microbial contamination of syringes during preparation: the direct influence of environmental cleanliness and risk manipulations on end-product quality.

PURPOSE The direct influence of environmental cleanliness and risk manipulations on prepared syringes was evaluated. METHODS Media-fill testing was used to estimate potential microbial contamination. Syringes were prepared in three different environments using four different uncontrolled high-risk manipulations. The three environments included an International Organization for Standardization...

متن کامل

Calculation of airborne cleanliness and air supply rate for non-unidirectional airflow cleanrooms

When designing a cleanroom to achieve a required airborne cleanliness standard or grade, such as specified in ISO 1464411 or the European Union Guidelines to Good Manufacturing Practice (EU GGMP)2, designers have difficulties deciding how much filtered air should be supplied to the cleanroom to achieve the correct airborne cleanliness requirement. Currently, this decision is based on experience...

متن کامل

ارزیابی پارامترهای عملکردی در فیلترهای هپا در یک صنعت دارویی(مطالعه موردی1394)

Abstract: Background and aims: Nowadays, cleanrooms have become impartible parts of an industry with sensitive products. Sources of contamination in cleanrooms are impaired performance and quality sensitive products in the cleanrooms .The aim of this study was to evaluate the efficiency of HEPA filter and check the concentration and number of airborne particles in cleanrooms for pharmaceutic...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • American journal of health-system pharmacy : AJHP : official journal of the American Society of Health-System Pharmacists

دوره 62 22  شماره 

صفحات  -

تاریخ انتشار 2005