Templated Non-Oxide Sol-Gel Preparation of Well-Ordered Macroporous (inverse opal) Ta3N5 Films
نویسندگان
چکیده
Reactions of Ta(NMe2)5 and n-propylamine are shown to be an effective system for sol-gel processing of Ta3N5. Ordered macroporous films of Ta3N5 on silica substrates have been prepared by infiltration of such a sol into close-packed sacrificial templates of cross-linked 500 nm polystyrene spheres followed by pyrolysis under ammonia to remove the template and crystallize the Ta3N5. Templates with long-range order were produced by controlled humidity evaporation. Pyrolysis of a sol-infiltrated template at 600 °C removes the polystyrene but does not crystallize Ta3N5, and X-ray diffraction shows nanocrystalline TaN plus amorphous material. Heating at 700 °C crystallizes Ta3N5 while retaining a high degree of pore ordering, whereas at 800 °C porous films with a complete loss of order are obtained.
منابع مشابه
Colloidal co-assembly route to large-area, high-quality photonic crystals
Whereas considerable interest exists in self-assembly of well-ordered, porous "inverse opal" structures for optical, electronic, and (bio)chemical applications, uncontrolled defect formation has limited the scale-up and practicality of such approaches. Here we demonstrate a new method for assembling highly ordered, crack-free inverse opal films over a centimeter scale. Multilayered composite co...
متن کاملAssembly of large-area, highly ordered, crack-free inverse opal films.
Whereas considerable interest exists in self-assembly of well-ordered, porous "inverse opal" structures for optical, electronic, and (bio)chemical applications, uncontrolled defect formation has limited the scale-up and practicality of such approaches. Here we demonstrate a new method for assembling highly ordered, crack-free inverse opal films over a centimeter scale. Multilayered composite co...
متن کاملNanocrystalline Precursors for the Co-Assembly of Crack-Free Metal Oxide Inverse Opals.
Inorganic microstructured materials are ubiquitous in nature. However, their formation in artificial self-assembly systems is challenging as it involves a complex interplay of competing forces during and after assembly. For example, colloidal assembly requires fine-tuning of factors such as the size and surface charge of the particles and electrolyte strength of the solvent to enable successful...
متن کاملCharge transport under illumination in mesoporous continuous films
Recent developments in the preparation of surfactant-templated mesostructured sol-gel silica materials have extended the morphology from the originally discovered powders, with particle sizes on the order of microns, to mesoporous continuous thin films. These films could find applications in membrane-based separations, selective catalysis and sensors. Particularly, sodium dodecyl sulfate (SDS)t...
متن کاملPreparation and Characterization of WO3 Electrochromic Films Obtained by the Sol-Gel Process
Tungsten trioxide (WO3) films have been coated on indium thin oxide (ITO) conductive glass substrate, using aqueous solution of peroxotungstic acid (PTA) by the sol-gel dip coating method. X-ray diffractometery (XRD) analysis confirmed monoclinic and triclinic structure for the film and powdered WO3 respectively. Fourier transforms infrared spectroscopy (FT-IR) exhibit...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره 52 شماره
صفحات -
تاریخ انتشار 2013