Superconducting Linac Design Concepts for a next Generation Light Source at Lbnl*

نویسندگان

  • J. N. Corlett
  • J. Byrd
  • L. Doolittle
  • P. J. Emma
  • A. Ratti
  • F. Sannibale
  • M. Venturini
  • R. Wells
  • S. Zimmermann
  • C. M. Ginsburg
  • R. D. Kephart
  • A. L. Klebaner
  • T. J. Peterson
  • A. I. Sukhanov
چکیده

GENERATION LIGHT SOURCE AT LBNL* J.N. Corlett, J. Byrd, L. Doolittle, P.J. Emma, A. Ratti, F. Sannibale, M. Venturini, R. Wells, S. Zimmermann, LBNL, Berkeley, CA, USA C.M. Ginsburg, R.D. Kephart, A.L. Klebaner, T.J. Peterson, A.I. Sukhanov, FNAL, Batavia, IL, USA D. Arenius, G.R. Neil, T. Powers, J.P. Preble, TJNAF, Newport News, VA, USA C. Adolphsen, C.D. Nantista, SLAC, Stanford, CA, USA Abstract The NGLS collaboration is developing design concepts for a multi beamline soft X ray FEL array powered by a superconducting linear accelerator, operating in CW mode, with a high bunch repetition rate of approximately 1 MHz [1]. The superconducting linear accelerator design concept is based on existing TESLA and ILC technology, to be developed for this CW application in a light source. We outline design options and preferred approaches to the linac.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

EUROPEAN ORGANISATION FOR NUCLEAR RESEARCH CERN – PS DIVISION CERN NUFACT Note 084 CERN/PS 2001-050 (RF) DESIGN OF THE SUPERCONDUCTING SECTION OF THE SPL LINAC AT CERN

In order to set up a powerful proton source for a future Neutrino Factory, increasing at the same time the flux of protons available for new and existing facilities, CERN is studying a 2.2 GeV superconducting Hlinac for 4 MW beam power, called SPL. The superconducting part of this linac covers the energy range from 120 MeV to 2.2 GeV. Three sections made of 352 MHz cavities with nominal ß of 0....

متن کامل

Resistive Wall Heating of the Undulator in High Repetition Rate Fels*

In next generation high repetition rate FELs, beam energy loss due to resistive wall wakefields will produce significant amount of heat. The heat load for a superconducting undulator (operating at low temperature), must be removed and will be expensive to remove. In this paper, we study this effect in an undulator proposed for a Next Generation Light Source (NGLS) at LBNL. We benchmark our calc...

متن کامل

Optimization and beam dynamics of a superconducting radio-frequency gun

Recent advances in superconducting radio-frequency (RF) technology and a better understanding of RF photoinjector design optimization make it possible to propose a specific design for a superconducting RF gun that can simultaneously produce both ultra-high peak brightness and high average current. Such a device is a critical component of next generation X-ray sources, such as self-amplified spo...

متن کامل

Design of the Driver Linac for the Rare Isotope Accelerator *

ACCELERATOR * P.N. Ostroumov, J.A. Nolen and K.W. Shepard, ANL, Argonne, IL 60439, USA Abstract The proposed design of the Rare Isotope Accelerator (RIA) driver linac is a cw, fully superconducting, 1.4 GV linac capable of accelerating uranium ions up to 400 MeV/u and protons to 1 GeV with 400 kW beam power. An extensive research and development effort has resolved many technical issues related...

متن کامل

New synchrotron radiation sources and the next-generation light sources.

Last December, the Swiss Light Source (SLS) at the Paul Scherrer Institute, located close to Zurich, became the latest third-generation synchrotron radiation source to come on-line (see Editorial, March 2001). Since its ®rst stored beam (1.6 mA) on 19 December 2000, it has continued to make rapid progress towards user operation. In May 2001, a gap of 6.5 mm was achieved with an in-vacuum undula...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2013