Experimental and theoretical evidence of a highly ordered two-dimensional Sn/Ag alloy on Si111.

نویسندگان

  • Jacek R Osiecki
  • H M Sohail
  • P E J Eriksson
  • R I G Uhrberg
چکیده

The existence of a highly ordered, two-dimensional, Sn/Ag alloy on Si(111) is reported in this study. We present detailed atomic and electronic structures of the one atomic layer thick alloy, exhibiting a 2 × 2 periodicity. The electronic structure is metallic due to a free-electron-like surface band dispersing across the Fermi level. By electron doping, the electronic structure can be converted into a semiconducting state. A rotated Sn trimer constitutes the key structural element that could be identified by a detailed analysis of constant energy contours derived from the free-electron-like band.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Effects of Sn, Ga, and In additives on properties of Ag-Pd-Au-Cu alloy for ultra-low fusing ceramics.

Nine 35% Ag-30% Pd-20% Au-15% Cu alloys containing 2, 4 and 6 mass% of Sn, Ga or In as an additive metal were experimentally prepared to investigate the effects of different additives and their content on the physical and mechanical properties as well as the bond with a ultra-low fusing ceramic. Both the different additives and their content or either of these two factors significantly influenc...

متن کامل

Development of metal-resin composite restorative material. Part 4. Flexural strength and flexural modulus of metal-resin composite using Ag-In alloy particles as filler.

The flexural strength and flexural modulus of an experimental metal-resin composite, which used Ag-In alloy particle as the filler, were evaluated. The effect of acid treatment and heat treatment on the Ag-In alloy particle was investigated. The flexural strength of the experimental metal-resin composites ranged from 65.5 MPa to 91.0 MPa. The flexural strength of the metal-resin composite incre...

متن کامل

Theoretical study of Drug Delivery on Sn (CH3)2(N-acetyl-L-cysteinate) with SWCNT

The interaction of anticancer drug Sn (CH3)2(N-acetyl-L-cysteinate) with carbon nanotube (CNT)is investigated by Quantum chemical ab initio calculations at FIF/ (LanL2DZ+STO-3G) and HF/(LanL2DZ+6-31G) levels in gas phase and solution. The solvent effect is taken into account viathe self-consistent reaction field (SCRF) method. Carbon nanotubes can act as a suitable drugdelivery vehicle for inte...

متن کامل

Effects of growth rate on the physical and mechanical properties of Sn-3.7Ag-0.9Zn eutectic alloy

Sn-3.7wt.%Ag-0.9wt.%Zn alloy was directionally solidified upward under different conditions, with different growth rates (V = 3.38 220.12 μm/s) at a constant temperature gradient (G = 4.33 K/mm) and with different temperature gradients (G = 4.33 -12.41 K/mm) at a constant growth rate (V = 11.52 μm/s) by using a Bridgman-type directional solidification furnace. The microstructure was observed to...

متن کامل

Influence of Ag micro-particle additions on the microstructure, hardness and tensile properties of Sn-9Zn binary eutectic solder alloy

In this study, an addition of Ag micro-particles (8–10 lm) with a content in the range between 0 and 1.5 wt.% to Sn–9Zn eutectic solder, were examined in order to understand the effect of Ag additions as the particulate reinforcement on the microstructural and mechanical properties as well as the thermal behavior of the newly developed composite solders. Here, an approach to prepare a micro-com...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Physical review letters

دوره 109 5  شماره 

صفحات  -

تاریخ انتشار 2012