Intercomparison of research and practical sand transport models

نویسندگان

  • A. G. Davies
  • J. van de Graaff
چکیده

A series of model intercomparisons, and model comparisons with field data, was carried out as part of the EU MASTIII SEDMOC Project (1998–2001). Initially, seven ‘research’ models were intercompared over a wide range of wave and current conditions, corresponding to both plane and rippled sand beds. These models included both one-dimensional vertical (1DV) formulations, varying in complexity from eddy viscosity and mixing length models to a full two-phase flow formulation, and also 2DV formulations capable of representing vortex shedding above sand ripples. The model results showed greatest convergence for cases involving plane beds, with predicted sand transport rates agreeing to well within an order of magnitude, and greatest divergence for cases involving rippled beds. A similar intercomparison involving (mainly) practical sand transport models, carried out over wide wave and current parameter ranges, also showed greatest variability in cases involving rippled beds. Finally, (mainly) practical models were compared with field data obtained at five contrasting field sites. The results showed that suspended sand concentrations in the bottom metre of the flow were predicted within a factor of 2 of the measured values in 13% to 48% of the cases considered, and within a factor of 10 in 70% to 83% of the cases, depending upon the model used. Estimates of the measured longshore component of suspended sand transport yielded agreement to within a factor of 2 in 22% to 66% of cases, and within a factor of 10 in 77% to 100% of cases. The results suggest that, at the present stage of research, considerable uncertainty should be expected if untuned models are used to make absolute predictions for field conditions. The availability of some measurements on site still appears to be a necessary requirement for high-accuracy sand transport predictions. However, for morphological modellers, the results may be viewed as more encouraging, since many of the present models exhibit agreement in their relative behaviour over wide ranges of wave and current conditions, which is a prerequisite to obtaining correct morphodynamic predictions. D 2002 Elsevier Science B.V. All rights reserved.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Prediction of Sediment Transport Capacity in Rivers Using Quasi Two-Dimensional Mathematical Model

Sediment rating curve is an essential factor for many river engineering subjects and computations such as dredging, design of storage dams, river intakes design and sand mining management. Although, this curve is established using simultaneous measurement of flow and sediment transport discharges, however, due to lack of reliable data during flood events, it has limited reliability in flood con...

متن کامل

Prediction of sand transport rates by waves and currents in the coastal zone

The predictions of a sand transport research model and Bijker’s (J. Waterways, Harbours Coastal Eng. Div. ASCE 97 (WW4) (1971) 687) engineering model are compared with data obtained in wave-current conditions at three field sites. A key element in the present study is that the bed roughness at the three sites has been estimated from predictions of the sand ripple dimensions. The comparisons bet...

متن کامل

Sediment Transport Modelling for Coastal Morphodynamics

The accurate prediction of sand transport rates in the coastal zone depends not only upon the choice of sediment transport model but also, rather critically, upon the formulation used to predict the bed roughness (ks). Sand transport rates are modelled here using both a One-equation, turbulence-closure, TKE-model and also Bijker’s sand transport model. Following some remarks about the nature an...

متن کامل

Formulating Fine to Medium Sand Erosion for Suspended Sediment Transport Models

The capacity of an advection/diffusion model to predict sand transport under varying wave and current conditions is evaluated. The horizontal sand transport rate is computed by vertical integration of the suspended sediment flux. A correction procedure for the near-bed concentration is proposed so that model results are independent of the vertical resolution. The method can thus be implemented ...

متن کامل

Overview of Reverse Osmosis for Chemical Engineers. Part 2: Applications of Transport Models

This second part of the overview of reverse osmosis investigates the ability of membrane transport models, presented in Part 1, to describe and/or predict membrane performance under different operating conditions. The problem of using the transport models to describe mixed solute systems is also discussed. The emphasis is to provide a simple, practical, and yet comprehensive summary of the most...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002