Direct measurement of the reaction front in chemically amplified photoresists.
نویسندگان
چکیده
The continuing drive by the semiconductor industry to fabricate smaller structures using photolithography will soon require dimensional control at length scales comparable to the size of the polymeric molecules in the materials used to pattern them. The current technology, chemically amplified photoresists, uses a complex reaction-diffusion process to delineate patterned areas with high spatial resolution. However, nanometer-level control of this critical process is limited by the lack of direct measurements of the reaction front. We demonstrate the use of x-ray and neutron reflectometry as a general method to measure the spatial evolution of the reaction-diffusion process with nanometer resolution. Measuring compositional profiles, provided by deuterium-labeled reactant groups for neutron scattering contrast, we show that the reaction front within the material is broad rather than sharply defined and the compositional profile is altered during development. Measuring the density profile, we directly correlate the developed film structure with that of the reaction front.
منابع مشابه
Determining Free Volume Changes During the PEB and PAB of a Chemically Amplified Resist
Chemically amplified resists provide some trade-off between resolution and amplification. While it is necessary for a single photogenerated acid to be mobile enough to cause several deprotection reactions, this inevitably leads to some linewidth spread. An acid molecule mobile enough to travel to several reaction sites is also mobile enough to move into unexposed regions of the resist. In order...
متن کاملMeasurement of the Spatial Evolution of the Deprotection Reaction Front with Nanometer Resolution using Neutron Reflectometry
The use of chemically amplified photoresists for the fabrication of sub-100 nm features will require spatial control with nanometer level resolution. To reach this goal, a detailed understanding of the complex reaction-diffusion mechanisms at these length scales is needed and will require high spatial resolution measurements. In particular, few experimental methods can directly measure the spat...
متن کاملCharacterization of a Chemically Amplified Photoresist for Simulation using a Modified “Poor Man’s DRM” Methodology
As we enter the DUV lithography generation, the developmental phase of the photolithography process is becoming crucial due to the high costs associated with the lithography equipment. Improvements in the modeling of chemically amplified resists are necessary to extract the maximum possible information from the minimum amount of experimentation. The poor man’s dissolution rate monitor (drm) met...
متن کامل3-D Diffusion Models for Chemically-Amplified Resists Using Massively Parallel Processors
Three-dimensional concentration dependent diffusions and simultaneous chemical reactions in chemically-amplified photoresists are simulated. Fickian, a linearly increasing diffusivity and an exponentially increasing diffusivity due to free volume increase with T-BOC are considered. Two different grid to processor mappings are proposed in implementing the simulator on massively parallel processo...
متن کاملBeyond EUV lithography: a comparative study of efficient photoresists' performance
Extreme ultraviolet (EUV) lithography at 13.5 nm is the main candidate for patterning integrated circuits and reaching sub-10-nm resolution within the next decade. Should photon-based lithography still be used for patterning smaller feature sizes, beyond EUV (BEUV) lithography at 6.x nm wavelength is an option that could potentially meet the rigid demands of the semiconductor industry. We demon...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Science
دوره 297 5580 شماره
صفحات -
تاریخ انتشار 2002