On the study of local-stress rearrangements during quasi-static plastic shear of a model glass: do local-stress components contain enough information?
نویسندگان
چکیده
We present a numerical study of the mechanical response of a 2D Lennard-Jones amorphous solid under steady quasi-static and athermal shear. We focus here on the evolution of local stress components. While the local stress is usually taken as an order parameter in the description of the rheological behaviour of complex fluids, and for plasticity in glasses, we show here that the knowledge of local stresses is not sufficient for a complete description of the plastic behaviour of our system. The distribution of local stresses can be approximately described as resulting from the sum of localized quadrupolar events with an exponential distribution of amplitudes. However, we show that the position of the center of the quadrupoles is not related to any special evolution of the local stress, but must be described by another variable.
منابع مشابه
Plastic response of a 2D Lennard-Jones amorphous solid: detailed analysis of the local rearrangements at very slow strain rate.
We analyze in detail the atomistic response of a model amorphous material submitted to plastic shear in the athermal, quasi-static limit. After a linear stress-strain behavior, the system undergoes a noisy plastic flow. We show that the plastic flow is spatially heterogeneous. Two kinds of plastic events occur in the system: quadrupolar localized rearrangements, and shear bands. The analysis of...
متن کاملConnecting Local Yield Stresses with Plastic Activity in Amorphous Solids.
In model amorphous solids produced via differing quench protocols, a strong correlation is established between local yield stress measured by direct local probing of shear stress thresholds and the plastic rearrangements observed during remote loading in shear. This purely local measure shows a higher predictive power for identifying sites of plastic activity when compared with more conventiona...
متن کاملNumerical and Experimental Study on Ratcheting Behavior of Plates with Circular Cutouts under Cyclic Axial Loading
In this paper, accumulation of plastic deformation of AISI 1045 steel plates with circular cutouts under cyclic axial loading is studied. Loading was applied under force-control conditions. Experimental tests were performed using a Zwick/Roell servo hydraulic machine. Under force-control loading with nonzero mean force, plastic strain was accumulated in continuous cycles called ratcheting. Nume...
متن کاملThe shear band controlled deformation in metallic glass: a perspective from fracture.
Different from the homogenous deformation in conventional crystalline alloys, metallic glasses and other work-softening materials deform discontinuously by localized plastic strain in shear bands. Here by three-point bending test on a typical ductile Pd-Cu-Si metallic glass, we found that the plastic deformed region during fracture didn't follow the yielding stress distribution as the conventio...
متن کاملLiquefied Residual Strength of Undrained Sand upon A Parametric Approach to Hypo-elastic Model
A parametric study approach evaluating drained/undrained behavior of sand has been developed as a simple/quick hypo-elastic model capable of being used in engineering applications. The volumetric interaction of sand grains behavior against pore water pressure induces the tendency of soil mass volume change to contract/dilate due to variation of effective mean stress on solid grain, pore water p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- The European physical journal. E, Soft matter
دوره 26 3 شماره
صفحات -
تاریخ انتشار 2008