Concentration, chemical bonding, and etching behavior of P and N at the SiO2/SiC(0001) interface

نویسندگان

  • Y. Xu
  • C. Xu
  • G. Liu
  • H. D. Lee
  • S. M. Shubeita
  • C. Jiao
  • A. Modic
  • A. C. Ahyi
  • Y. Sharma
  • A. Wan
  • J. R. Williams
  • T. Gustafsson
  • S. Dhar
  • E. L. Garfunkel
  • L. C. Feldman
چکیده

Articles you may be interested in Atomic state and characterization of nitrogen at the SiC/SiO2 interface Phosphorous and nitrogen are electrically active species at the SiO 2 /SiC interface in SiC MOSFETs. We compare the concentration, chemical bonding, and etching behavior of P and N at the SiO 2 /SiC(0001) interface using photoemission, ion scattering, and secondary ion mass spectrometry. Both interfacial P and N are found to be resistant to buffered HF solution etching at the SiO 2 /SiC(0001) interface while both are completely removed from the SiO 2 /Si interface. The medium energy ion scattering results of etched phosphosilicate glass/SiC not only provide an accurate coverage but also indicate that both the passivating nitrogen and phosphorus are confined to within 0.5 nm of the interface. Angle resolved photoemission shows that P and N are likely situated in different chemical environments at the interface. We conclude that N is primarily bound to Si atoms at the interface while P is primarily bound to O and possibly to Si or C. Different interface passivating element coverages and bonding configurations on different SiC crystal faces are also discussed. The study provides insights into the mechanisms by which P and N passivate the SiO 2 /SiC(0001) interface and hence improve the performance of SiC MOSFETs. V C 2015 AIP Publishing LLC.

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Silane and bonding of Resins to Ceramic

Silane and bonding of Resins to Ceramic Dr. K. Seyyedan* - Dr. M. Kalalipoor** - Dr. M. Javan***Assistant Professor of Fixed Prosthodontics Dept., Faculty of Dentistry, Shaheed Beheshti University of Medical Sciences. **Resident of Fixed Prosthodontics Dept., Faculty of Dentistry, Shaheed Beheshti University of Medical Sciences. Background and Aim: When bonding between two different dental mate...

متن کامل

TENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY

Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...

متن کامل

An evaluation on the effects of 37% phosphoric acid and self – etching primer on shear bond strength of enamel

An evaluation on the effects of 37% phosphoric acid and self – etching primer on shear bond strength of enamel Dr. A. Davari* - Dr. H. Hajizadeh* - Dr. H. Sharifikhatoonabadi** *- Assistant Professor of Operative Dentistry Dept. - Faculty of Dentistry - Yazd University of Medical Sciences. **- Dentist. Background and Aim: The goal of this study was to evaluate the effects of 37% phosphoric acid...

متن کامل

Rearrangement of the oxide-semiconductor interface in annealed Al2O3/4H-SiC structures

Al2O3 films with different thicknesses have been deposited on n-type nitrogen-doped 4H-SiC 0001 epitaxial samples by atomic layer chemical vapor deposition at 300 °C and subsequently annealed in Ar atmosphere at temperatures up to 1000 °C. The Al2O3/4H-SiC structures were analyzed by x-ray photoelectron spectroscopy XPS , secondary ion mass spectrometry SIMS , and transmission electron microsco...

متن کامل

A look underneath the SiO2/4H-SiC interface after N2O thermal treatments

The electrical compensation effect of the nitrogen incorporation at the SiO2/4H-SiC (p-type) interface after thermal treatments in ambient N2O is investigated employing both scanning spreading resistance microscopy (SSRM) and scanning capacitance microscopy (SCM). SSRM measurements on p-type 4H-SiC areas selectively exposed to N2O at 1150 °C showed an increased resistance compared to the unexpo...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2015