Measuring individual carbon nanotubes and single graphene sheets using atomic force microscope infrared spectroscopy.

نویسندگان

  • Matthew R Rosenberger
  • Michael Cai Wang
  • Xu Xie
  • John A Rogers
  • SungWoo Nam
  • William P King
چکیده

Although reasonable endeavours have been taken to obtain all necessary permissions from third parties to include their copyrighted content within this article, their full citation and copyright line may not be present in this Accepted Manuscript version. Before using any content from this article, please refer to the Version of Record on IOPscience once published for full citation and copyright details, as permission will likely be required. All third party content is fully copyright protected, unless specifically stated otherwise in the figure caption in the Version of Record.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Measuring the uniaxial strain of individual single-wall carbon nanotubes: resonance Raman spectra of atomic-force-microscope modified single-wall nanotubes.

Raman spectroscopy is used to measure the strain in individual single-wall carbon nanotubes, strained by manipulation with an atomic-force-microscope tip. Under strains varying from 0.06%-1.65%, the in-plane vibrational mode frequencies are lowered by as much as 1.5% (40 cm(-1)), while the radial breathing mode (RBM) remains unchanged. The RBM Stokes/anti-Stokes intensity ratio remains unchange...

متن کامل

Identifying individual single-walled and double-walled carbon nanotubes by atomic force microscopy.

We show that the number of concentric graphene cylinders forming a carbon nanotube can be found by squeezing the tube between an atomic force microscope tip and a silicon substrate. The compressed height of a single-walled nanotube (double-walled nanotube) is approximately two (four) times the interlayer spacing of graphite. Measured compression forces are consistent with the predicted bending ...

متن کامل

Heptamethine Cyanine Dyes in the Design of Photoactive Carbon Nanomaterials

Near-infrared (NIR) absorbing nanomaterials, built from anionic heptamethine cyanine dyes and single-walled carbon nanotubes or few-layer graphene, are presented. The covalent linkage, using 1,3-dipolar cycloaddition reactions, results in nanoconjugates that synchronize the properties of both materials, as demonstrated by an in-depth characterization study carried out by transmission electron m...

متن کامل

Magnetic force microscopy using fabricated cobalt-coated carbon nanotubes probes

Magnetic force microscope ( MFM ) is a powerful technique for mapping the magnetic force gradient above the sample surface. Herein, single-wall carbon nanotubes (SWCNT) were used to fabricate MFM probe by dielectrophoresis method which is a reproducible and cost-effective technique. The effect of induced voltage on the deposition manner of carbon nanotubes (CNT) on the atomic force microscope (...

متن کامل

Study on the Effect of Silanization and Improvement in the Tensile Behavior of Graphene-Chitosan-Composite

In the present study, silane-functionalized graphene (f-graphene)-reinforced chitosan nanocomposite films exhibiting enhanced mechanical properties have been prepared by the solution casting method. These nanocomposite films were characterized by X-ray diffraction, Raman spectroscopy and thermogravimetric analysis. In order to investigate the effect of silane functionalization, tensile tests we...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:
  • Nanotechnology

دوره 28 35  شماره 

صفحات  -

تاریخ انتشار 2017