Title Thermally induced conduction type conversion in n-type InP
نویسندگان
چکیده
منابع مشابه
19.2% Efficient InP Heterojunction Solar Cell with Electron-Selective TiO2 Contact
We demonstrate an InP heterojunction solar cell employing an ultrathin layer (∼10 nm) of amorphous TiO2 deposited at 120 °C by atomic layer deposition as the transparent electron-selective contact. The TiO2 film selectively extracts minority electrons from the conduction band of p-type InP while blocking the majority holes due to the large valence band offset, enabling a high maximum open-circu...
متن کامل14.2 Nano-scale Type-II InP/GaAsSb DHBTs to Reach THz Cutoff Frequencies
We demonstrate vertically and laterally scaled GaAsSb/InP type-II DHBTs with fT = 670 GHz at 10.3 mA/μm emitter current density and off-state collector-emitter breakdown voltage BVCEO = 3.2 V. Small-signal modeling is used to extract delay terms and to identify material design and device fabrication requirements for next-generation devices with > 1 THz cutoff frequencies. INTRODUCTION InP based...
متن کاملTwin superlattice-induced large surface recombination velocity in GaAs nanostructures
Photovoltaic effects on Franz–Keldysh oscillations in photoreflectance spectra: Application to determination of surface Fermi level and surface recombination velocity in undoped Ga As ∕ n-type GaAs epitaxial layer structures Detection of surface states in GaAs and InP by thermally stimulated exoelectron emission spectroscopy Temperature dependence of photoluminescence spectra in InAs/GaAs quant...
متن کاملPhotoelectrochemical Etching of InAs
Photoelectrochemieal etching of n-InAs (Eg = 0.36 eV) is demonstrated. Although the concentration of thermally generated minority carriers and saturation current are high compared to larger bandgap semiconductors, photocurrent to dark current ratios as high as 4:1 were obtained at low temperature (2°C) and at potentials near the flatband potential. A surface film primarily composed of arsenic o...
متن کاملElectrical Properties and Interface States of Rare-Earth Metal Ytterbium Schottky Contacts to p-Type InP
The electronic parameters and interface state properties of Yb/p-InP Schottky diode have been investigated by currentvoltage (IV), capacitancevoltagefrequency (CVf ) and conductancevoltagefrequency (GVf ) measurements at room temperature. The barrier height and ideality factor of the Yb/p-InP Schottky diode are found to be 0.68 eV (IV)/0.79 eV (CV) and 1.24, respectively. As well, t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 1999