- 223 - the " Cadme " Approach to the Interface of Solid Modellers
نویسنده
چکیده
This work st and s as a ~ontribution in the area of the man-ma -::hin e -::Qmmuni~ations. In the f ield of Computer Aided Design the solu ti on of su-::h a problem has led us to the definition and realization of an indipendent in terfa-::e pla-::ed in front of solid modellers a-::~epting C.S.G. definitions. This s ystem is able to simu late the orthographi~ proje-::tio ns of the spe-::ified part without a~t i vat ing the solid modeller. The illustrated interfa-::e is a part of an integra ted system -::alled CADHE.
منابع مشابه
Reflection and Transmission of Longitudinal Wave at Micropolar Viscoelastic Solid/Fluid Saturated Incompressible Porous Solid Interface
In this paper, the reflection and refraction of longitudinal wave from a plane surface separating a micropolar viscoelastic solid half space and a fluid saturated incompressible half space is studied. A longitudinal wave (P-wave) impinges obliquely at the interface. Amplitude ratios for various reflected and transmitted waves have been obtained. Then these amplitude ratios have been computed nu...
متن کاملThermal Simulation of Solidification Process in Continuous Casting
In this study, a mathematical model is introduced to simulate the coupled heat transfer equation and Stefan condition occurring in moving boundary problems such as the solidification process in the continuous casting machines. In the continuous casting process, there exists a two-phase Stefan problem with moving boundary. The control-volume finite difference approach together with the boundary ...
متن کاملDevelopment of decision support tool for municipal solid waste management system in Iran based on life cycle assessment approach
Background and Objective: Various aspects including the environmental burdens, social and economic consequences of the waste management(WM) scenarios must be considered to come up with a comprehensive WM plan. Life Cycle Assessment (LCA) approach is a systematic method to quantify the environmental burdens of each WM scenario. Materials and Methods: This study used an LCA approach to develop a...
متن کاملاثر نسبت حجمی مذاب- جامد و سرعت دوران بر فصل مشترک جفت فلزی منیزیم- آلومینیم در ریختهگری گریز از مرکز
In this study, centrifugal casting process was used for producing Al/Mg bimetal. Molten Mg was poured at 700 oC, with 1.5 and 3 melt-to-solid volume ratio (Vm/Vs) into the 450 oC preheated solid Al rotating at 800, 1200, 1600 and 2000 rpm. Castings were kept inside the centrifuged casting machine and cooled down to 150 oC. Investigating the effect of melt-to-solid volume ratio showed that incre...
متن کاملInvestigation of Vacancy Defects on the Young’s Modulus of Carbon Nanotube Reinforced Composites in Axial Direction via a Multiscale Modeling Approach
In this article, the influence of various vacancy defects on the Young’s modulus of carbon nanotube (CNT) - reinforcement polymer composite in the axial direction is investigated via a structural model in ANSYS software. Their high strength can be affected by the presence of defects in the nanotubes used as reinforcements in practical nanocomposites. Molecular structural mechanics (MSM)/finite ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2015