Electromagnetic Crosstalk Penalty in 2 . 5 GB / s and 1 OGB / S Serial optical modules

نویسندگان

  • Xiaomin Jin
  • Fei Wang
  • H. Sendaula
چکیده

Electromagnetic crosstalk poses a serious problem in advanced serial communication modules. This paper focuses on the primary sources of crosstalk penalty in a 2.5 Gb/s optic transceiver and a 1OGb/s optic transponder. A novel method to quantify the crosstalk penalty by observing a receiver's bit-error-ratio (BER) versus transmitter to receiver signal phase is proposed. A coupled microstrip transmission line model is also explored to demonstrate inductive crosstalk coupling.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Mitigation of Rayleigh crosstalk using noise suppression technique in 10-Gb/s REAM-SOA.

We demonstrate a mitigation of Rayleigh back-scattering (RBS) impact in 10-Gb/s reflective electroabsorption modulator monolithically integrated with semiconductor optical amplifier (REAM-SOA). The technique is based on the intensity-noise suppression of the centralized incoherent seed-light, which enables smooth evolution of deployed DWDM applications. We exhibit the power penalty of less than...

متن کامل

ISSCC 2011 / SESSION 25 / CDRs & EQUALIZATION TECHNIQUES / 25 . 7 25 . 7 A 10 Gb / s Half - UI IIR - Tap Transmitter in 40 nm CMOS

Two commercially important standards for 10Gb/s serial data transfer include the SFI specification, associated with SFP+ optical modules and copper twinaxial cable [1], and the 10GBASE-KR specification for backplane channels in computer servers and networking equipment [2]. The SFI specification requires the transmitter to operate with both low data-dependent jitter (DDJ) and low transmitter wa...

متن کامل

Optical Interconnect System Integration for Ultra-Short-Reach Applications

It is predicted that the increase in microprocessor clock frequency will create bandwidth limitations for copper interconnects on Printed Circuit Boards (PCB) due to signal attenuation, Electromagnetic Interference (EMI) and crosstalk [1]. Optical interconnects could be a viable solution to these problems. This paper explores the potential and challenges for optical interconnects in UltraShort-...

متن کامل

Performance Degradation of 100 Gb/s PM-QPSK and 400 Gb/s PM- 16QAM Single Carrier and Dual Carrier Coherent Systems Due to Cascaded Optical Filters

ABSTRACT In this paper, we studied the performance degradation of single-carrier and dual-carrier 100 Gb/s and 400 Gb/s systems due to optical filter cascade with 50 and 100/150 GHz channel spacing, respectively. Eye closure penalty (ECP) is used as a performance evaluation metric, where we use two types of filters: fiber Bragg grating (FBG) and thin-film filters (TFF). Simulation results indic...

متن کامل

40 Gb/s optical subassembly module for a multi-channel bidirectional optical link.

A 40 Gb/s bidirectional optical link using four-channel optical subassembly (OSA) modules and two different wavelengths for the up- and down-link is demonstrated. Widely separated wavelengths of 850 nm and 1060 nm are used to reduce the optical crosstalk between the up- and down-link signals. Due to the integration capabilities of silicon, the OSA is implemented, all based on silicon: V-grooved...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2009