Evaluation of Low-Inductance Capacitor Configurations for High Frequency Circuit Board Decoupling
نویسندگان
چکیده
منابع مشابه
Controlling Power-Distribution-Plane Resonance in Multilayer Printed Circuit Boards
This paper describes the mechanisms of powerdistribution-plane resonance in multilayer printed circuit boards and the techniques to control the resonance. The powerdistribution-plane resonance is responsible for high-level emissions and circuit malfunctions. Controlling the resonance is an effective technique, so adequate characterization of the resonance is necessary to achieve control. The re...
متن کاملESR and ESL of Ceramic Capacitor Applied to Decoupling Applications
Power distribution system noise affects computer product timing performance, signal integrity and electromagnetic interference. Between 1 MHz and 1 GHz, the primary means of reducing power distribution noise is with ceramic decoupling capacitors. To achieve a certain target impedance, it is important to characterize the ESR of ceramic decoupling capacitors as they directly determine the number ...
متن کاملEffective Decoupling Radius of Decoupling Capacitor*
Decoupling capacitors on packages and printed circuits boards are often essential to reduce voltage fluctuations and maintain power and signal integrity. This paper presents a measure for the evaluation of effectiveness of decoupling capacitors placed on package or board structures.
متن کاملQuantifying Decoupling Capacitor Location
Decoupling capacitor location in DC power bus design is a critical design choice for which proven guidelines are not well established. The mutual inductance between two closely spaced vias can have a great impact on the coupling between an IC and a decoupling capacitor. This coupling is a function of the spacing between the IC and capacitor, and spacing between power and ground layers. The impa...
متن کاملBroadband Reduction of Swiching Noise By Embedding High-Density Thin-Film Capacitor In a Laminated Package
Broadband noise reduction has been investigated by embedding a high-density thin-film decoupling capacitor as much as 1 μF in a laminate package. A complex programmable logic device (CPLD) was mounted on the laminate package instead of bare chip as a noise generating circuits. Then, the package was mounted on an evaluation board. Eight output buffer circuits of the CPLD were simultaneous switch...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2011