Chapter 6: Influence of Mixed Soft Segments of Ultra-low Monol Poly(propylene glycol), Poly(tetramethylene ether glycol) and Tri(propylene glycol) on Structure-Property Relationships of Poly(urethane-urea)s

Study of Surface Tension of Binary Mixtures of Poly (Ethylene Glycol) in Water and Poly (Propylene Glycol) in Ethanol and its Modeling Using Neural Network

Hydrolytic degradation and protein release studies of thermogelling polyurethane copolymers consisting of poly[(R)-3-hydroxybutyrate], poly(ethylene glycol), and poly(propylene glycol).

This paper reports the hydrolytic degradation and protein release studies for a series of newly synthesized thermogelling tri-component multi-block poly(ether ester urethane)s consisting of poly[(R)-3-hydroxybutyrate] (PHB), poly(propylene glycol) (PPG), and poly(ethylene glycol) (PEG). The poly(PEG/PPG/PHB urethane) copolymer hydrogels were hydrolytically degraded in phosphate buffer at pH 7.4...

The Effect of Type and Dosage of Frothers on Coarse Particles Flotation

Frothers havea profoundeffectonbubble size and also flotation efficiency. In present study the effect of type and dosage of frothers on the flotation response of coarse particles of quartz was investigated.  Therefore, flotation response of coarse particles using frothers such as MIBC, pine oil, poly propylene glycol with concentration of 0, 25, 50 and 75...

New biodegradable thermogelling copolymers having very low gelation concentrations.

New biodegradable multiblock amphiphilic and thermosensitive poly(ether ester urethane)s consisting of poly[(R)-3-hydroxybutyrate] (PHB), poly(ethylene glycol) (PEG), and poly(propylene glycol) (PPG) blocks were synthesized, and their aqueous solutions were found to undergo a reversible sol-gel transition upon temperature change at very low copolymer concentrations. The multiblock poly(ether es...

Effect of Ethylene Oxide Functional Groups in PEBA-CNT Membranes on CO2/CH4 Mixed Gas Separation

Poly (ether-block-amide) /poly (ethylene glycol)/ carbon nanotubes mixed matrix membranes have been successfully fabricated using solvent evaporation method to determine the effect of ethylene oxide groups on the performance of produced membranes. The effects of CNTs (2-8 wt%) and PEG (up to 50 wt%)were investigated in both single and mixed gas test setup in different temperature and pressure. ...