A single active nanoelectromechanical tuning fork front-end radio-frequency receiver.
نویسندگان
چکیده
Nanoelectromechanical systems (NEMS) offer the potential to revolutionize fundamental methods employed for signal processing in today's telecommunication systems, owing to their spectral purity and the prospect of integration with existing technology. In this work we present a novel, front-end receiver topology based on a single device silicon nanoelectromechanical mixer-filter. The operation is demonstrated by using the signal amplification in a field effect transistor (FET) merged into a tuning fork resonator. The combination of both a transistor and a mechanical element into a hybrid unit enables on-chip functionality and performance previously unachievable in silicon. Signal mixing, filtering and demodulation are experimentally demonstrated at very high frequencies ( > 100 MHz), maintaining a high quality factor of Q = 800 and stable operation at near ambient pressure (0.1 atm) and room temperature (T = 300 K). The results show that, ultimately miniaturized, silicon NEMS can be utilized to realize multi-band, single-chip receiver systems based on NEMS mixer-filter arrays with reduced system complexity and power consumption.
منابع مشابه
A New Analog-based LO Harmonic Rejection Technique with Tunable Notch Frequency
An effective technique for mixer LO harmonic rejection in a SAW-less wideband receiver front-end is proposed. The proposed technique provides a tunable notch that can be placed at any frequency like mixer LO harmonics, to avoid the aliasing in baseband after mixing. An analog LC notch is used in a cascode transconductor, and it can reject one of the 3rd or 5th harmonics. T...
متن کاملA Tunable Wideband Rf Front-end for Sdr
Today’s direct-conversion SDR platforms are capable of tuning over extremely wide frequency ranges compared to traditional superheterodyne transceiver architectures. However, these radios can suffer from a number of problems due to a lack of front-end RF filtering, including poor dynamic range and desensitization. In this paper, we examine preliminary work on a tunable bandpass filter we are de...
متن کاملBroadband Receiver for Software Defined Radio in Giga-hz Range Based on 40nm Si Technology Broadband Receiver for Software Defined Radio in Giga-hz Range Based on 40nm Si Technology
In this paper, a low voltage ultra-wideband RF receiver for Software-Defined Radio (SDR) is presented. In SDR design, the radio frequency (RF) receiver should be able to receive signals over a broadbandwidth so that it can satisfy a variety of different communication standards. In the proposed design, working frequency ranging from 0.1GHz to 6GHz RF front-end for SDR, covering almost all of mat...
متن کاملA 2.4 GHz 3.6mW 0.35mm2 Quadrature Front-End RX for ZigBee and WPAN Applications
a cheaper design. Since an LC-oscillator topology is mandatory to achieve a minimal current draw, the reduction of the number of coils has to be done in the LNA, the mixer and the quadrature generator. In this work, starting from the LNA-Mixer and VCO (LMV) cell topology [2], a single-coil low-power receiver shares the bias current among all the RF blocks of the analog front-end. The receiver p...
متن کاملTime-multiplexed single front-end multiple-input multiple-output receivers with preserved diversity gain
A design technique to realise a low-complexity multiple-input multiple-output (MIMO) receiver using a timemultiplexed single front-end receiver is introduced. The architecture uses a simple front-end receiver where it delivers radio frequency signals to baseband section. The theory behind this architecture is analysed and the diversity gain of the proposed receiver is investigated. This simple ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Nanotechnology
دوره 23 22 شماره
صفحات -
تاریخ انتشار 2012