Comparative Study of the Flexural Strength of Three Fiber-Reinforced Composites

ثبت نشده
چکیده

Received Jan. 2012; Received in revised form June 2012; Accepted June 2012. ABSTRACT Statement of Problem: After 30 years of intermittent reports in the literature, the use of fiber-reinforcement is just now experiencing rapid expansion in dentistry. However, there are some controversy reports in the amounts of flexural strength of fiber reinforced composites to use them as bridges. Purpose: The purpose of this study was to evaluate the flexural strength of three commercially available fiber-reinforced composites including Belle Glass, GC Gradia, and Signum. Materials and Method: Thirty uniform bars of 25×2×2 mm (10 for each group) were fabricated as their manufacturers recommended. Then all specimens were loaded to failure using a three-point bending test and flexural strength was determined. Results: The mean flexural strength of Belle Glass (386.65 MPa) was significantly ( p < 0.0001) higher than that of GC Gradia (219.25 MPa) and Signum (172.89 MPa). There was no significant difference between GC Gradia and Signum in flexural strength. Conclusion: On the basis of these findings, Belle Glass can be used in clinical practice with greater confidence compared to GC Gradia and Signum. Corresponding author: Salehi M. Dept. of Prosthodontics, School of Dentistry, Shiraz University of Medical Sciences, Shiraz, Iran Tel: 0098-0711-6353348 Fax: 0098-0711-2349583 E-mail: [email protected]

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Flexural Behavior of Cementitious Composites Reinforced by Synthetic Fibers

The application of fibers to reinforce cementitious materials is a well-known subject. At first, asbestos fibers are used in industrial process to produce fiber reinforced cement sheets. Thereafter, various types of synthetic fibers are produced and used as asbestos substitutes. The aim of the present work is to evaluate the effect of synthetic fibers on the flexural behavior of cementitious co...

متن کامل

Investigation of Mechanical Properties of Lithium-Based Geopolymer Composites Reinforced with Basalt Fibers

Recently, geopolymer binders have been considered because of low cost, simple processes for synthesis and many raw materials in nature. Geopolymer with brittle nature does not have high strength and cannot be used alone for structural materials. Therefore, to use in different structures, the composite which is reinforced with fibers such as carbon, glass, basalt, etchasbeen used. In this resear...

متن کامل

The influence of cellulose pulp and cellulose microfibers on the flexural performance of green-engineered cementitious composites

The aim of this study was to investigate the flexural behavior of engineered cementitious composites (ECCs) reinforced by cellulose pulp (CP) and cellulose microfibers (CMF). The reinforcements were obtained from chemical-mechanical treatments of Kraft paper and used in ECC mix design. Results showed that cement reinforced by CP exhibited a strain-hardening behavior in the three-point bending t...

متن کامل

CHARACTERIZATION OF SHORT E-GLASS FIBER REINFORCEDGRAPHITE AND BRONZE FILLED EPOXY MATRIX COMPOSITES

The mechanical characterization of short E- glass fiber reinforced, graphite and sintered bronze filled epoxy composite was carried out in this study. The aim of the present study was to develop tribological engineering material. In this study the flexural strength, theoretical and experimental density, Hardness and Impact strength of composites was investigated experimentally. The results show...

متن کامل

Effect of Redmud Particulates on Mechanical Properties of BFRP Composites (TECHNICAL NOTE)

This article reports the effective usage of redmud(RM) an industrial waste ,as a  novel filler in polymer matrix. The composite has been fabricated with redmud as secondary reinforcement in banana fiber reinforced polyester (BFRP) using compression molding technique. The mechanical properties such as tensile, flexural and impact strength have been studied for different fiber weight percentage, ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2012