Automated Edge Grid Generation Based on Arc-Length Optimization
نویسندگان
چکیده
1 High Performance Computing Collaboratory, Center for Advanced Vehicular Systems, Graduate Program in Computational Engineering, Mississippi State University, Mississippi State, MS, U.S.A. [email protected] 2 Department of Mathematics and Statistics, Department of Computer Science and Engineering, Center for Computational Sciences, Graduate Program in Computational Engineering, Mississippi State University, Mississippi State, MS, U.S.A. [email protected]
منابع مشابه
Adaptation of Structured Grid for Supersonic and Transonic Flows
Two distinct redistribution grids - adaptation techniques, spring analogy and elliptic grid generator are applied to two-dimensional steady, inviscid, shocked flows, and the ability of each technique is examined and compared. Euler equations are solved base on Roe's Reimann solver approach to simulate supersonic flow around a sphere, transonic flow about an airfoil and supersonic flow in a symm...
متن کاملCombined Use of Sensitivity Analysis and Hybrid Wavelet-PSO- ANFIS to Improve Dynamic Performance of DFIG-Based Wind Generation
In the past few decades, increasing growth of wind power plants causes different problems for the power quality in the grid. Normal and transient impacts of these units on the power grid clearly indicate the need to improve the quality of the electricity generated by them in the design of such systems. Improving the efficiency of the large-scale wind system is dependent on the control parameter...
متن کاملOptimization of grid independent diesel-based hybrid system for power generation using improved particle swarm optimization algorithm
The power supply of remote sites and applications at minimal cost and with low emissions is an important issue when discussing future energy concepts. This paper presents modeling and optimization of a photovoltaic (PV)/wind/diesel system with batteries storage for electrification to an off-grid remote area located in Rafsanjan, Iran. For this location, different hybrid systems are studied and ...
متن کاملOptimal grids for five-axis machining
This paper presents a new grid generation method for tool path planning for five-axis machining based on minimization of the kinematics error. First, the procedure constructs a space-filling curve so that the scallops between the resulting tracks of the tool do not exceed a prescribed tolerance. At the second stage (which is the subject of this paper) a one-dimensional grid along the space-fill...
متن کاملOptimal Placement and Sizing of DGs and Shunt Capacitor Banks Simultaneously in Distribution Networks using Particle Swarm Optimization Algorithm Based on Adaptive Learning Strategy
Abstract: Optimization of DG and capacitors is a nonlinear objective optimization problem with equal and unequal constraints, and the efficiency of meta-heuristic methods for solving optimization problems has been proven to any degree of complex it. As the population grows and then electricity consumption increases, the need for generation increases, which further reduces voltage, increases los...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2013