Multiprobe Impedance Measurement System For Nondestructive Evaluation And Test Of "green State" Powd - Instrumentation and Measurement, IEEE Transactions on
نویسندگان
چکیده
This paper describes an instrument capable of detecting flaws in “green-state” (prior to sintering) powder metallurgy (P/M) parts. The instrument uses a matrix of impedance measurements from a multiprobe array that contacts the surface of the P/M part. The array of measured data is processed to not only detect the presence of flaws but determine their location, size, and orientation as well. Experimental results show detection of flaws ranging in size from 10–200 m.
منابع مشابه
Multiprobe impedance measurement system for nondestructive evaluation and test of "green state" powder metallurgy parts
This paper describes an instrument capable of detecting flaws in "green-state" (prior to sintering) powder metallurgy (P/M) parts. The instrument uses a matrix of impedance measurements from a multiprobe array which contacts the surface of the P/M part. The array of measured data is processed to not only detect the presence of flaws, but also determine their location, size, and orientation. Exp...
متن کاملAn Advanced State Estimation Method Using Virtual Meters
- Power system state estimation is a central component in energy management systems of power system. The goal of state estimation is to determine the system status and power flow of transmission lines. This paper presents an advanced state estimation algorithm based on weighted least square (WLS) criteria by introducing virtual meters. For each bus of network, except slack bus, a virtual meter...
متن کاملMulti-objective Measurement Devices Allocation Using State Estimation in Distribution System
Allocation of measurement devices is a necessity of distribution system which is an application of state estimation. In this paper, the problem of active and reactive measurement devices is modeling using a multi-objective method. The objectives of the problem are to minimize the use of measurement devices, increase in state estimation output, improve the state estimation quality and reduce cos...
متن کاملDesign of a broadband multiprobe reflectometer
A new design approach for low-cost multiprobe reflectometers is presented. While traditional circuits adopt equally spaced probes, the solution presented here provides a method to greatly enhance the bandwidth of the measuring system by a proper choice of each probe position. As an example, a five-probe (1–16) GHz reflectometer was designed and the measurement results compared to those obtained...
متن کاملRobust state estimation in power systems using pre-filtering measurement data
State estimation is the foundation of any control and decision making in power networks. The first requirement for a secure network is a precise and safe state estimator in order to make decisions based on accurate knowledge of the network status. This paper introduces a new estimator which is able to detect bad data with few calculations without need for repetitions and estimation residual cal...
متن کامل