Impulse Response Measurements Using All-Pass Deconvolution
نویسنده
چکیده
A method of measuring impulse responses of rooms will be described which uses time reversed electronic reverberation from a single pulse as the excitation. The room response, recorded on DAT, is decoded by playing the tape back through the reverberator. The output can be heard, recorded, or analyzed. The method improves S/N by 20 dB and can be implemented with approximately 14 multiples/sample on a PC.
منابع مشابه
UDECON: deconvolution optimization software for restoring high-resolution records from pass-through paleomagnetic measurements
The rapid accumulation of continuous paleomagnetic and rock magnetic records acquired from pass-through measurements on superconducting rock magnetometers (SRM) has greatly contributed to our understanding of the paleomagnetic field and paleo-environment. Pass-through measurements are inevitably smoothed and altered by the convolution effect of SRM sensor response, and deconvolution is needed t...
متن کاملSNR lidar signal improovement by adaptive tecniques
were P(t) is lidar observation after deconvolution process, strongly dependent on geometrical and optical characteristics of the sensor, and Pδ(t) is ideal observation when the response funtion of lidar sensor is a Diràc distribution, like ideal laser pulse. From (1), the additive noise term N(t) makes a direct deconvolution impossible. In general, deconvolution process with R(t) show a low-pas...
متن کاملRetrieving impulse response function amplitudes from the ambient seismic field
S U M M A R Y Seismic interferometry is now widely used to retrieve the impulse response function of the Earth between two distant seismometers. The phase information has been the focus of most passive imaging studies, as conventional seismic tomography uses traveltime measurements. The amplitude information, however, is harder to interpret because it strongly depends on the distribution of amb...
متن کاملDeconvolution of Sparse Signals and Images from Noisy Partial Data using MUSIC
Abstract— Deconvolution has three major difficulties: (1) the partial data issue–only the “valid” part of the convolution (which uses no image edge information) is known; (2) the lowpass nature of the impulse response (1D) or point-spread (2D) function; and (3) noise in the data. This paper shows that the second issue can be used to solve the first, and that sparsity side information can be use...
متن کاملA super-exponential deflation method incorporated with higher-order correlations for blind deconvolution of MIMO linear systems
The multichannel blind deconvolution of finite-impulse response (FIR) or infinite-impulse response (IIR) systems is investigated using the multichannel super-exponential deflation methods (MSEDMs). In the existing MSEDM, the so-called ‘‘second-order correlation method’’ is incorporated in order to estimate the contributions of an extracted source signal to the channel outputs. We propose a new ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2000