Mechanical performance of inflatable inserts used in limb prosthetics.
نویسندگان
چکیده
Inflatable insert products used to overcome residual limb shrinkage were evaluated in a bench test environment under compressive loading conditions. Pressure-loss tests under static loading demonstrated that after inserts were inflated to 43.4 to 45.6 kPa, insert pressures reduced from 0.09%/min to 1.36%/min in the first 5 min and from 0.00%/min to 0.27%/min in the subsequent 55 min. As inserts were inflated, they demonstrated at least two phases in their pressure versus thickness curves: A relatively low-slope portion (Phase I) was followed by a high-slope portion (Phase II). The transition from Phase I to Phase II occurred at more than a 12-mm thickness, a thickness greater than that considered acceptable for practical clinical use (10 mm). This result suggests that in a socket, stress to resist insert expansion is taken by the residual limb and socket more than by the insert itself. Cyclic-loading tests under constrained thickness conditions demonstrated that local stiffness was more sensitive to insert pressure than to constraint spacing (insert thickness). The static and dynamic test results help to explain why some users claim that inserts do not provide equal and consistent support unless inflated to a very high insert pressure. An insert that allowed adjustment of the location of the Phase I to Phase II transition point in the pressure versus thickness curve might help to overcome these limitations.
منابع مشابه
Investigating the Effect of Virtual Reality Environment and Intelligent Control Panel on the Rehabilitation of Upper Limb
Introduction: Occupational therapy and performing specific motor activities are among the healing processes for injured people that should be followed by patients in need after the doctor’s prescription. The objective of this study was to evaluate the effect of using virtual reality environments and interacting with hardware designed for the treatment and rehabilitation of patients with upper l...
متن کاملInvestigating the Effect of Virtual Reality Environment and Intelligent Control Panel on the Rehabilitation of Upper Limb
Introduction: Occupational therapy and performing specific motor activities are among the healing processes for injured people that should be followed by patients in need after the doctor’s prescription. The objective of this study was to evaluate the effect of using virtual reality environments and interacting with hardware designed for the treatment and rehabilitation of patients with upper l...
متن کاملMulti-Objective Optimization of Tio2-Water Nanofluid Flow in Tubes Fitted With Multiple Twisted Tape Inserts in Different Arrangement
In this paper, experimentally derived correlations of heat transfer and pressure drop are used in a Pareto based Multi-Objective Optimization (MOO) approach to find the best possible combinations of heat transfer and pressure drop of TiO2-water nanofluid flow in tubes fitted with multiple twisted tape inserts in different arrangement. In this study there are four independent design variables: t...
متن کاملBallistic Performance of Hybrid Armor with Ceramic Inserts and Polymeric Matrix for Different Threat Levels (TECHNICAL NOTE)
Ceramic materials due to their high compressive strength and hardness have been one of prime candidates in armor design in particular when high level threads (impact velocity above 600m/s) are involved. The aim of this work is to investigate ballistic impact resistance potential for a target plate with novel ceramic inserts as against ceramic tiles. Two size 98% alumina (AL2O3) base ceramic i...
متن کاملCosmetic covers for lower-limb prostheses.
A soft cosmetic cover for use with modular endoskeletal prostheses is discussed. The reverse molding procedure, which is used to make a mirror image of a unilateral amputee's remaining anatomical limb, is described . This process reduces the time required to fabricate a cosmetic cover since no mechanical or artistic shaping is required to match the prosthetic limb to the anatomical limb. The re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Journal of rehabilitation research and development
دوره 38 4 شماره
صفحات -
تاریخ انتشار 2001