Biomechanical effects of multi-level laminoplasty and laminectomy: an experimental and finite element investigation
نویسنده
چکیده
Cervical spondylotic myelopathy is the most common spinal cord disorder in persons over 55 years of age in North America and perhaps in the world. Surgical options are broadly classified into two categories namely, anterior and posterior approaches. This study focuses on the posterior based approach (i.e. laminectomy or laminoplasty) which is considered when multiple levels of the spine have to be decompressed or when most of the cord compression results from posterior pathological conditions. The external and internal behavior of the spine after laminoplasty and laminectomy has been evaluated using both experimental and computational methods. Computationally, a validated intact 3D finite element model of the cervical spine (C2-T1) was modified to simulate laminectomy and laminoplasty (open door (ODL) and double door (DDL)) at levels C3-C6. During flexion, after ODL the adjacent levels C2C3 and C6-C7 showed a 39% and 20% increase in the motion respectively; while no substantial changes were observed at the surgically altered levels. The percent increase in motion after DDL varied from 4.3% to 34.6%. The inclination towards increased motion during flexion after double door laminoplasty explains the role of the lamina-ligamentum flavum complex in the stability of spine. Compared to the intact model, laminectomy at C3-C6 led to a profound increase (37.5% to 79.6%) in motion across the levels C2-C3 to C6-C7. Furthermore, the changes in the von Mises stresses of the intervertebral disc observed after laminoplasty and laminectomy during flexion can be correlated to the changes in the intersegmental motions. An in-vitro biomechanical study was conducted to address the effects of laminoplasty (two-level and four-level) and four-level laminectomy on the flexibility of the cervical spine. Both two-level and four-level laminoplasty resulted in minimal changes in C2-T1 range of motion. For flexion/extension, two-level and multi-level laminoplasty showed an approximate 20% decrease (p>0.05) in the range of motion at
منابع مشابه
BIOMECHANICAL EFFECTS OF LAMINOPLASTY AND LAMINECTOMY ON THE STABILITY OF CERVICAL SPINE INTRODUCTION Relevant Anatomy: The spinal column is made up of series of motion
متن کامل
Influence of an Inclusion on Multi-Pass Copper Shaped-Wire Drawing by 2D Finite Element Analysis
The size and length effects of an inclusion on multi-pass copper shaped-wire drawing were investigated. For this purpose, an experimental investigation on optimal die half-angle was conducted. Based on experimental data of optimal die half-angle, wire and inclusion deformations, drawing and hydrostatic stress of copper shaped-wires that contain an inclusion were calculated by two-dimensional fi...
متن کاملResults of Cervical Recapping Laminoplasty: Gross Anatomical Changes, Biomechanical Evaluation at Different Time Points and Degrees of Level Involvement
BACKGROUND Recapping laminoplasty has become the frequently-used approach to the spinal canal when bone decompression of the vertebral canal is not the goal. However, what changes will occur after surgery, and whether recapping laminoplasty can actually reduce the risk of delayed deformities remains unknown. METHODOLOGY We designed an animal experiment using a caprine model, and partitioned t...
متن کاملImproved Seismic Performance of Chevron Brace Frames Using Multi-Pipe Yield Dampers
Spacious experimental and numerical investigation has been conducted by researchers to increase the ductility and energy dissipation of concentrically braced frames. One of the most widely used strategies for increasing ductility and energy dissiption, is the use of energy-absorbing systems. In this regard, the cyclic behavior of a chevron bracing frame system equipped with multi-pipe dampers (...
متن کاملCervical Laminoplasty: The History and the Future
Cervical laminoplasty was developed as an alternative to cervical laminectomy for treatment of cervical myelopathy, in which hinges are created to lift the lamina. Various techniques of laminoplasty have since been developed after two prototype techniques: Hirabayashi's open-door laminoplasty and Kurokawa's spinous process splitting (double-door) laminoplasty. Several in vitro studies report su...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2016