Two-dimensional Optical Parallel Transmission Using a Verticalsavity Surface Emitting Laser X 4 Fan-out Spot Generator Using Gaas the Fabrication and Characterization of Nana-ape*
نویسنده
چکیده
No.1, Roosevelt Rd,. Sec. 4, TaGei, Taiwan 106, R.O.C. Phone: 886-2-2363525 1, Fax: 886-2-23678254, E-mail: [email protected] Shyh-Lin Tsao Institute of Electro-Optical Science and Technology, National Taiwan Normal University, No.88, Ting-ChouiRd,. Sec. 4, Taipei, Taiwan 116, R.O.C. Phone: 886-2-29350349, FAX: 886-2-29350382, E-mail: [email protected],tw Abstract Analysis of rhe minimized physical size and increasing of optical coupling intensity are considered using 8 x 8 VCSEL array and microlens array scaled ro 4 mm' area.
منابع مشابه
Fabrication and Optical Characterization of Zinc Oxide Nanoparticles Prepared via a Simple Sol-gel Method
In this research zinc oxide (ZnO) nano-crystalline powders were prepared by sol-gel method using zinc acetate. The ZnO nanoparticles were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), ultraviolet-visible (UV-Vis), Fourier transform infra-red (FT-IR) and energy dispersive X-ray (EDX) spectroscopy. The structure of nanoparticles was studied using XRD pattern. The c...
متن کاملFabrication and Optical Characterization of Silicon Nanostructure Arrays by Laser Interference Lithography and Metal-Assisted Chemical Etching
In this paper metal-assisted chemical etching has been applied to pattern porous silicon regions and silicon nanohole arrays in submicron period simply by using positive photoresist as a mask layer. In order to define silicon nanostructures, Metal-assisted chemical etching (MaCE) was carried out with silver catalyst. Provided solution (or materiel) in combination with laser interference lithogr...
متن کاملPreparation and Characterization of ZnO Nanoparticles by Laser Ablation in NaOH Aqueous Solution
In the recent years, laser ablation in liquid has become an increasingly important technique for the fabrication of NPs. this paper reports our recent studies on the generation of ZnO NPs by ablation of metal targets in aqueous environments using Q-switch Nd-YAG laser (λ=532nm) immersed in NaOH (0.1M). The Surface topography studied by atomic force microscopy revealed wider size distributio...
متن کاملFabrication and Characterization of the Fiber Optical Taper for a Surface Plasmon Resonance Sensor
For a fiber optical surface plasmon resonance (SPR) sensor a short part of its cladding should be removed to coat a thin layer of a metal. Usually this is problematic when an optical fiber with small core diameter is used. In this paper, a new method using µliter droplet of the HF acid for short fiber optical taper fabrication is reported. Using this method in a multi-mode optical fiber w...
متن کاملBasic Study on an Optical Network Module Using Surface Emitting Lasers
1. Introduction The key part of the optical network module that we are proposingg1],2] is a two dimensional optical element consisted of the vertical cavity surface-emitting laser (VCSEL) arrays and the switching devices with optical lter. In this paper, we report on a study of the fabrication technologies of a distributed Bragg reeector (DBR) for VCSEL and optical lter for the switching device...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2004