A 256k@32-bit Capture Card for the IIP Radiometer

نویسنده

  • Grant Hampson
چکیده

The digital part of the radiometer project is broken into several stages of development (Digital IF, APB, FFT, etc) and it is important to be able to capture results from each stage. It is of equal importance that each stage be capable of interfacing to the proceeding stage. Consequently a standard interface was developed using a high density 68-pin SCSI3 connector. This is the same connector which is used to interface data to the PC using the PCI-DIO-32HS digital acquisition card [2]. A photograph of the capture board is shown in Figure 1, where the male connector (black) is the input to the capture card and the female connector (silver) is the PCI-DIO-32HS interface connector. Each of the radiometer development stages will have a similar connector layout.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Comparing Different Methodologies Used To Ensure the Security of RFID Credit Card: A Comparative Analysis

The use of Radio Frequency Identification (RFID) advancement is turning out to be rapidly transversely over an extensive variety of business undertakings. Engineers apply the development not simply in customary applications, for instance, asset or stock after, also in security organizations, electronic travel papers and RFID-embedded card. In any case, RFID development moreover brings different...

متن کامل

Comparing Different Methodologies Used To Ensure the Security of RFID Credit Card: A Comparative Analysis

The use of Radio Frequency Identification (RFID) advancement is turning out to be rapidly transversely over an extensive variety of business undertakings. Engineers apply the development not simply in customary applications, for instance, asset or stock after, also in security organizations, electronic travel papers and RFID-embedded card. In any case, RFID development moreover brings different...

متن کامل

AD9054 Prototype Evaluation

Introduction This document describes the development of a 200MHz analogue-to-digital converter acquisition evaluation system. In particular an AD9054 Evaluation board [1] was purchased from Analog Devices for $200. This board is interfaced via an Altera ACEX FPGA and 256k × 18− bit FIFO to the PC using a PCI-DIO-32HS digital acquisition card [2]. Figure 1 illustrates the evaluation setup: the A...

متن کامل

Initial Plan for a Precision Temperature Sensor

Precision microwave radiometry requires accurate internal calibration sources. A microwave terminator is one such internal source, and, under the assumption of a high quality match, produces a noise power directly proportional to the physical temperature of the terminator. Precise measurement of this temperature is required in order to provide a quality calibration standard. It is desirable for...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2002