One-piece casting for fixed bridgework.
نویسندگان
چکیده
A laboratory technique suitable for one-piece casting of short or long span bridges and its application to a seven-unit one-piece cast bridge is described. (Received for puhlicution August, 1980. Revised October, 1981.)
منابع مشابه
The ovate pontic for fixed bridgework.
UNLABELLED The provision of fixed prosthodontic restorations that meets the patient's functional and aesthetic demands can be challenging, especially in the anterior maxilla. It requires close communication with the technician and knowledge of the available options. This article will outline the options for pontic design and focus on the ovate pontic, which has the potential to provide the most...
متن کاملCementum status in natural teeth opposing implant-borne bridgework in Macaca fascicularis.
OBJECTIVE The objective of this study was to investigate the cementum status in natural teeth opposing implant-supported bridgework. METHODS Maxillary premolars and molars opposing immediate-loading (IL) and delayed-loading (DL) mandibular implant-supported bridgework in 4 Macaca fascicularis were harvested after 3 months of functional loading. Another 2 monkeys without mandibular fixed prost...
متن کاملNew abutment for a screw-retained, implant-supported crown.
The 1-piece, implant-supported abutment and crown, colloquially described as the UCLA abutment, commonly is used to fabricate single, screw-retained crowns. This abutment was designed to allow attachment of the crown directly to the implant and requires a waxing and casting procedure by a laboratory technician. A new prefabricated abutment has been developed that uses a similar approach but doe...
متن کاملMultiple-unit implant frames: one-piece casting vs. laser welding and brazing.
The linear distortion of prostheses over implants, one-piece casting and cast in sections followed by laser welding by laser and brazing was evaluated in an edentulous mandibular model with five parallel abutments, with a distance of 10mm from center to center. Seventy five gold cylinders were tightened with screws on the abutments with 10Ncm torque. The cylinder/analogue assemblies were measur...
متن کاملFit Analysis of Different Framework Fabrication Techniques for Implant-Supported Partial Prostheses.
PURPOSE This study evaluated the vertical misfit of implant-supported frameworks made using different techniques to obtain passive fit. MATERIALS AND METHODS Thirty three-unit fixed partial dentures were fabricated in cobalt-chromium alloy (n = 10) using three fabrication methods: one-piece casting, framework cemented on prepared abutments, and laser welding. The vertical misfit between the f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Australian dental journal
دوره 27 1 شماره
صفحات -
تاریخ انتشار 1982