Multiband LNA Design and RF-Sampling Front-Ends for Flexible Wireless Receivers

The wireless market is developing very fast today with a steadily increasing number of users all around the world. An increasing number of users and the constant need for higher and higher data rates have led to an increasing number of emerging wireless communication standards. As a result there is a huge demand for flexible and low-cost radio architectures for portable applications. Moving towards multistandard radio, a high level of integration becomes a necessity and can only be accomplished by new improved radio architectures and full utilization of technology scaling. Modern nanometer CMOS technologies have the required performance for making high-performance RF circuits together with advanced digital signal processing. This is necessary for the development of low-cost highly integrated multistandard radios. The ultimate solution for the future is a software-defined radio, where a single hardware is used that can be reconfigured by software to handle any standard. Direct analog-to-digital conversion could be used for that purpose, but is not yet feasible due to the extremely tough requirements that put on the analog-to-digital converter (ADC). Meanwhile, the goal is to create radios that are as flexible as possible with today’s technology. The key to success is to have an RF front-end architecture that is flexible enough without putting too tough requirements on the ADC. One of the key components in such a radio front-end is a multiband multistandard low-noise amplifier (LNA). The LNA must be capable of handling several carrier frequencies within a large bandwidth. Therefore it is not possible to optimize the circuit performance for just one frequency band as can be done for a single application LNA. Two different circuit topologies that are suitable for multiband multistandard LNAs have been investigated, implemented, and measured. Those two LNA topologies are: (i) wideband LNAs that cover all the frequency bands of interest (ii) tunable narrowband LNAs that are tunable over a wide range of frequency bands. Before analog-to-digital conversion the RF signal has to be downconverted to a frequency manageable by the analog-to-digital converter. Recently the concept of direct sampling of the RF signal and discrete-time signal processing before analog-to-digital conversion has drawn a lot of attention. Today’s CMOS tech-