Using Titanium-Reinforced PTFE Membranes

ثبت نشده
چکیده

Objective: To evaluate the rate of graft resorption in autogenous iliac bone grafting (IBG) and guided bone regeneration (GBR) in patients with atrophic maxillae. Material and methods: We performed a retrospective study involving patients requiring implant placement who underwent IBG or GBR. Volumetric changes of the graft sites were evaluated by imaging studies. The primary predictor and outcome variables were augmentation technique and rate of volumetric resorption, respectively. Secondary outcome variables included bone gain, success of grafting, insertion torque of implants, and requirement for vestibuloplasty. Results: The sample comprised 39 patients (21 with GBR and 18 with IBG). One patient in the IBG group had temporary sensory disturbance at the donor site, and one patient in the GBR group had late exposure of the nonresorbable membrane. The average values of percent volume reduction in the GBR and IBG groups were 12.26% ± 2.35% and 35.94% ± 7.94%, respectively, after healing and 15.87% ± 1.99% and 41.62% ± 6.97%, respectively, at last follow-up. The IBG group exhibited a significantly higher reduction in bone volume than the GBR group at both time points (P = .001). The mean values of horizontal and vertical bone gain after healing in the IBG group were significantly higher than those in the GBR group (P = .006 and P = .001, respectively). The mean implant torque during implant placement in the GBR group was significantly higher than that in the IBG group (P = .024). There was no significant difference in the requirement for vestibuloplasty between the two groups (P > .05). Conclusion: Although both hard tissue augmentation approaches provide an adequate volume of bone graft for implant insertion, IBG results in greater graft resorption at maxillary augmented sites than GBR. Clinicians should consider the differences in the extent of graft resorption between the two methods while choosing the treatment approach.

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Simultaneous implant placement and vertical ridge augmentation with a titanium-reinforced membrane: a case report.

The present report demonstrates a clinical approach to achieve vertical ridge augmentation around endosseous implants. Two implants were placed, leaving the threads exposed, in the atrophic mandibular right posterior quadrant of a male patient. Both implants were covered with a titanium-reinforced expanded polytetrafluoroethylene (e-PTFE) membrane. Second-stage surgery was performed 12 months a...

متن کامل

Evaluation of complication rates and vertical bone gain after guided bone regeneration with non‐resorbable membranes versus titanium meshes and resorbable membranes. A randomized clinical trial

BACKGROUND The partial edentulous posterior mandible is often a challenge area that requires a bone reconstructive surgery for implants placement. PURPOSE This RCT was aimed to evaluate complications rate and vertical bone gain after Guided Bone Regeneration (GBR) with dense non-resorbable d-PTFE titanium-reinforced membranes (Group A) versus titanium meshes covered by cross-linked collagen m...

متن کامل

Long-term clinical evaluation and SEM analysis of the e-PTFE and titanium membranes in guided tissue regeneration.

AIM This study aimed to evaluate clinical outcomes of titanium membrane and compare these findings with clinical outcomes of e-PTFE membrane, and to investigate the effect of bacterial contamination on both membranes with SEM during long-term healing. RESULTS Sixteen titanium and sixteen e-PTFE membranes were surgically placed adjacent to periodontally involved teeth. Seven titanium and 8 e-P...

متن کامل

Vertical ridge augmentation with titanium-reinforced, dense-PTFE membranes and a combination of particulated autogenous bone and anorganic bovine bone-derived mineral: a prospective case series in 19 patients.

PURPOSE This prospective case series evaluated the use of a new titanium-reinforced nonresorbable membrane (high-density polytetrafluoroethylene), in combination with a mixture of anorganic bovine bone-derived mineral (ABBM) and autogenous particulated bone, for vertical augmentation of deficient alveolar ridges. MATERIALS AND METHODS A mixture of ABBM and autogenous particulated bone was use...

متن کامل

Effects of rhBMP-2 Loaded Titanium Reinforced Collagen Membranes on Horizontal Bone Augmentation in Dogs

The aim of this study was to evaluate the efficacy of growth factor loaded collagen membranes on new bone formation during horizontal bone augmentation. Mandibular defects (4 × 4 × 4 mm) were surgically prepared in six male beagle dogs, which were then protected with one of three types of membranes: (1) titanium mesh, (2) titanium reinforced collagen, or (3) rhBMP-2 loaded titanium reinforced c...

متن کامل

Using Titanium-Reinforced PTFE Membranes

Severe vertical ridge deficiency in the anterior maxilla represents one of the most challenging scenarios in bone regeneration. Under ideal circumstances, guided bone regeneration in combination with soft tissue management has shown predictable esthetic and functional outcomes. Success largely relies on primary wound closure during and after the surgical procedure. Surgical sites present differ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2017