Multifluid Flows, Interface Capturing and Application to the Simulation of the Water Assisted Injection Molding Process
نویسنده
چکیده
In this paper, we present a 3D finite element approach to compute multifluid flows. Special attention is given to capture the water/polymer interface, that can be obtained used a VOF (Volume of Fluid) or a Level Set technique, with or without adaptative meshing. Results are shown, in for 2D and 3D parts.
منابع مشابه
Capillary Effects on Surface Enhancement in a Non-Homogeneous Fibrous Porous Medium
The evaluation of a free fluid surface in a porous medium has several mathematical applications that are important in industries using molds, particularly in the fluid injection process. The vacuum-assisted resin transfer molding (VARTM) process is a promising technology in the primary composite industry. An accurate computational simulation of the VARTM process would be a cost-effective tool i...
متن کاملSimulation and modeling of macro and micro components produced by powder injection molding: A review
During the recent years powder processing technologies have gained much attention due to the less energy consumption and recyclable powders. Manufacturing of complicated parts by the conventional powder metallurgy (PM) method is hard due to the uniaxial pressure, which leads to the low design flexibility. In order to prevail these constraints, powder injection molding (PIM) process, which inclu...
متن کاملA preconditioned solver for sharp resolution of multiphase flows at all Mach numbers
A preconditioned five-equation two-phase model coupled with an interface sharpening technique is introduced for simulation of a wide range of multiphase flows with both high and low Mach regimes. Harten-Lax-van Leer-Contact (HLLC) Riemann solver is implemented for solving the discretized equations while tangent of hyperbola for interface capturing (THINC) interface sharpening method is applied ...
متن کاملExperimental and Numerical Investigation of Thickness on the Shrinkage and out of Roundness in Cylindrical Parts in Injection Molding Process
Injection molding process is one of the most important methods of forming in the plastics manufacturing industry. Shrinkage and out of roundness are phenomenons that affect the final product quality. In this study, the effect of the thickness of cylindrical parts from polypropylene material on shrinkage and out of roundness has been investigated. For this purpose, injection molding process is s...
متن کاملExperimental and Simulation - Assisted Feasibility Study of Gas Injection to Increase Oil Recovery Using a Combination of Semi-VAPEX and GAGD Techniques
Gas injection into heavy oil reservoirs could result in high ultimate recovery of oil. Experimental studies showed that an application of a combined technology of Gas Assisted Gravity Drainage (GAGD) and Vapor Extraction (VAPEX) could increase final oil recovery of a candidate viscous oil reservoir. In this paper the results of laboratory investigation are presented, including Pressure-Volu...
متن کامل