Length dependent foam-like mechanical response of axially indented vertically oriented carbon nanotube arrays

نویسندگان

  • Matthew R. Maschmann
  • Qiuhong Zhang
  • Feng Du
  • Liming Dai
  • Jeffery Baur
چکیده

Matthew R. Maschmann , Qiuhong Zhang , Feng Du , Liming Dai , Jeffery Baur a,* a Air Force Research Laboratory, Materials and Manufacturing Directorate, AFRL/RX, Wright-Patterson Air Force Base, Ohio 45433, USA b Universal Technology Corporation, Dayton, Ohio 45432, USA c University of Dayton Research Institute, University of Dayton, Dayton, Ohio 45469, USA d Department of Chemical Engineering, Case Western University, Cleveland, Ohio 44106, USA

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Controllable viscoelastic behavior of vertically aligned carbon nanotube arrays

We have characterized the mechanical behavior of aligned carbon nanotube (CNT) arrays that serve as foam-like energy absorbing materials, by using atomic force microscope indentation. It is shown that the mechanical properties (e.g. elastic modulus, adhesion force, and energy dissipation) of aligned CNT arrays are dependent on the length of CNTs as well as chemical environment that surrounds CN...

متن کامل

Super-compressible foamlike carbon nanotube films.

We report that freestanding films of vertically aligned carbon nanotubes exhibit super-compressible foamlike behavior. Under compression, the nanotubes collectively form zigzag buckles that can fully unfold to their original length upon load release. Compared with conventional low-density flexible foams, the nanotube films show much higher compressive strength, recovery rate, and sag factor, an...

متن کامل

Multiscale Mass-Spring Models of Carbon Nanotube Arrays Accounting for Mullins-like Behavior and Permanent Deformation

Based on a one-dimensional discrete system of bistable springs, a mechanical model is introduced to describe plasticity and damage in carbon nanotube (CNT) arrays. The energetics of the mechanical system are investigated analytically, the stress-strain law is derived, and the mechanical dissipation is computed, both for the discrete case as well as for the continuum limit. An information-passin...

متن کامل

Tuning the compressive mechanical properties of carbon nanotube foam

A post-growth chemical vapor deposition (CVD) treatment was used to tune the compressive mechanical properties of carbon nanotube (CNT) arrays. Millimeter tall CNT arrays with low compressive resilience were changed to a foam-like material with high compressive strength and almost complete recovery upon unloading. The foam was tuned to provide a range of compressive properties for various appli...

متن کامل

In situ SEM observation of column-like and foam-like CNT array nanoindentation.

Quantitative nanoindentation of nominally 7.5 and 600 μm tall vertically aligned carbon nanotube (VACNT) arrays is observed in situ within an SEM chamber. The 7.5 μm array consists of highly aligned and weakly interacting CNTs and deflects similarly to classically defined cylindrical columns, with deformation geometry and critical buckling force well estimated using the Euler-Bernoulli theory. ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

ثبت نام

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

عنوان ژورنال:

دوره   شماره 

صفحات  -

تاریخ انتشار 2010