Mechanical impedance and absorbed power of hand-arm under x(h)-axis vibration and role of hand forces and posture.
نویسندگان
چکیده
The biodynamic responses of the hand-arm system under x(h)-axis vibration are investigated in terms of the driving point mechanical impedance (DPMI) and absorbed power in a laboratory study. For this purpose, seven healthy male subjects are exposed to two levels of random vibration in the 8-1,000 Hz frequency range, using three instrumented cylindrical handles of different diameters (30, 40 and 50 mm), and different combinations of grip (10, 30 and 50 N) and push (0, 25 and 50 N) forces. The experiments involve grasping the handle while adopting two different postures, involving elbow flexion of 90 degrees and 180 degrees, with wrist in the neutral position for both postures. The analyses of the results revealed peak DPMI magnitude and absorbed power responses near 25 Hz and 150 Hz, for majority of the test conditions considered. The frequency corresponding to the peak response increased with increasing hand forces. Unlike the absorbed power, the DPMI response was mostly observed to be insensitive to variations in the excitation magnitude. The handle diameter revealed obvious effects on the DPMI magnitude, specifically at frequencies above 250 Hz, which was not evident in the absorbed power due to relatively low velocity at higher frequencies. The influence of hand forces was also evident on the DPMI magnitude response particularly at frequencies. above 100 Hz, while the effect of hand-arm posture on the DPMI magnitude was nearly negligible. The magnitude of power absorbed within the hand and arm was observed to be strongly dependent upon the excitation level over the entire frequency range, while the influence of hand-arm posture on the total absorbed power was observed to be important. The effect of variations in the hand forces on the absorbed power was relatively small for the bent elbow posture, while an increase in either the grip or the push force coupled with the extended arm posture resulted in considerably higher energy absorption. The results suggested that the handle size, hand-arm posture and hand forces, produce coupled effect on the biodynamic response of the hand-arm system.
منابع مشابه
Study of the effect of hand-arm vibration on hand grip strength
Introduction: Musculoskeletal injuries are one of the most common causes of work-related illnes, reimbursement and absence among workers in working environments throughout the world. Among various factors, exposure to vibration is one of the main causes of these injuries. The aim of this study was to investigate the effect of key factors on the occurrence and exacerbation of the effects of expo...
متن کاملارزیابی مواجهه کاربران تیلر با ارتعاش دست و بازو
Introduction: The power tiller is a multipurpose hand tractor designed primarily for rotary tilling and other farm operations. Vibration, transmitted from the handles of the tiller to the operators’ body, causes many injuries such as, pain, musculoskeletal disorders and white finger syndrome. The aim of this study was to evaluate the hand-arm vibration exposure in the operators of tiller model...
متن کاملAbsorption of vibration energy in the human hand and arm.
A possible basis for the risk assessment for hand-transmitted vibration may be to determine the amount of energy absorbed in the human hand and arm. In the present study, the mechanical energy absorption in the hand-arm system was measured within the frequency range of 4 to 1000 Hz. The study was carried out on ten healthy subjects during exposure to sinusoidal vibration. The influence of vario...
متن کاملMechanical Impedances Distributed at the Fingers and Palm of the Human Hand in Three Orthogonal Directions
The objective of this study is to investigate the basic characteristics of the three axis mechanical impedances distributed at the fingers and palm of the hand subjected to vibrations along the three orthogonal directions (xh, yh, and zh). Seven subjects participated in the experiment on a novel threedimensional (3-D) hand-arm vibration test system equipped with a 3-D instrumented handle. The t...
متن کاملارزیابی مواجهه با ارتعاش دست و بازو و اثرات بهداشتی مرتبط با آن در کارگران سنگبری های شهر همدان
Introduction: The workers employed in stone cutting workplace are exposed to hand-arm vibration and its complications. The aim of this study was to evaluate the exposure to hand-arm vibration and its health effects on workers in the stone cutting workshops. Methods: In this descriptive-analytic study, 40 workers of Hamadan city stone cutting who worked with stone cutting machines were examin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
- Industrial health
دوره 43 3 شماره
صفحات -
تاریخ انتشار 2005