Optimized Uhf Antenna Design , Simulation , and Implementation
نویسنده
چکیده
منابع مشابه
A Cost-Effective Antenna Design for Printed UHF RFID
In this paper, the printed UHF RFID tag dipole antenna design is optimized to reduce the consumption of conductive material. The optimized design is achieved by narrowing the width of the low current density areas. The proposed optimized dipole antenna design requires less amount of conductive ink to achieve the equivalent radiation efficiency level as the ideal copper-trace dipole antenna. The...
متن کاملDesign and Fabrication of Plasma Array Antenna with Beam Forming
In this paper, the design and implementation of plasma antenna array with beam forming is discussed. The structure consists of a circular array of plasma tube enclosed in a unipolar UHF band monopole antenna. Beam forming is possible by stimulated plasma tubes. The combination of the above antenna with plasma excitation controller makes a beam forming smart antenna. An experimental model in UHF...
متن کاملDesign, Simulation and implementation of active dual-band dipole antenna using a series stub
In this paper, a new method for designing an active dual-band dipole antenna is proposed. The operating frequencies of the proposed antenna are 150 and 450 MHz that are usually used in military applications. Using a series stub is the main idea in the proposed dual-band antenna, where it makes an independent resonance frequency higher than the main resonance frequency of a conventional dipole. ...
متن کاملCircularly Polarized Tag Antenna for UHF RFID
Design of a circularly polarized tag antenna for UHF RFID applications is discussed and a planar tag antenna, based on series connected loop topology is designed. Simulation based design process for axial ratio optimization is discussed and the simulation and measurement results for the proposed tag antenna are presented.
متن کاملSystematic Design of High-Performance Smart Card with HF/UHF Dual-Band RFID Tag
Recently, there have been widely conducted researches on dual-band radio frequency identification (RFID) tag based on 13.56 MHz (HF) and 900 MHz (UHF). Most dual-band RFID tag has been implemented so that each antenna is separated in a different inlay sheet respectively, which makes the resulting smart card impractically thick, and the typical drawback of dual-band RFID tags incorporated in one...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2013