Quickly Design Co 2 – Amine Absorber
نویسندگان
چکیده
An integral rate-based model is used to find a quick and reliable estimate of the height of packing in a CO2alkanolamine absorber. Heat transfer in the gas phase is neglected. Due to the need to arrive at a quick estimate of the height of packing, this assumption is made. Starting from the bottom, the height of packing required for a small change in solute mole fraction in a differential section of the tower is calculated. An average of the enhancement factor calculated using film theory of mass transfer accompanied by chemical reaction for each boundary, is used. These calculations are repeated until at the top of the tower, the desired solute concentration is reached. The cumulative height gives total height of packing required. The method is illustrated.
منابع مشابه
Optimization of CO2 capture process with aqueous amines using response surface methodology
Amine is one of candidate solvents that can be used for CO2 recovery from the flue gas by conventional chemical absorption/desorption process. In this work, we analyzed the impact of different amine absorbents and their concentrations, the absorber and stripper column heights and the operating conditions on the cost of CO2 recovery plant for post-combustion CO2 removal. For each amine solvent, ...
متن کاملPlantwide Control of CO2 Capture by Absorption and Stripping Using Monoethanolamine Solution
In this study, plantwide control of an absorption/stripping CO2 capture process using mono-ethanol-amine was investigated using dynamic simulation. In this system, CO2 removal ratio is influenced by operating variables such as lean solvent rate and lean solvent loading, which is in-turn determined by reboiler duty in the stripper. Moreover, we found that the long term stability of the system ca...
متن کاملDesign of a Single-Layer Circuit Analog Absorber Using Double-Circular-Loop Array via the Equivalent Circuit Model
A broadband Circuit Analogue (CA) absorber using double-circular-loop array is investigated in this paper. A simple equivalent circuit model is presented to accurately analyze this CA absorber. The circuit simulation of the proposed model agrees well with full-wave simulations. Optimization based the equivalent circuit model, is applied to design a single-layer circuit analogue absorber using d...
متن کاملImproving CO2 adsorption with new amine-functionalized Y-type zeolite
In this work, a new synthesized Y-type zeolite with an Si/Al molar ratio of 2.5 (NaY) was modified with amines, in order to probe the influence of the modification of the adsorbent’s surface on CO2 adsorption. The three selected amines were diethanolamine, tetraethylenepentamine, and 2- methylaminoethanol. The surface nature of NaY was changed after amine modification, which causes a...
متن کاملComputational analysis of Nitrosamine Formation during Amine- Based CO2 Capture process with different Groups of Nitrosating Agents (NO-X)
In an amine-based CO2 capture from a coal-fired power plant, nitrosamines can be generated as a result of the reaction between impurities such as NOx (an example of a nitrosating agent) in the flue gas with amine solutions in the absorption column. There is the potential that the nitrosamines can be emitted to the atmosphere if adequate control measures are not put in place. As is well known, a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2009