Measurement of the velocity of light
ثبت نشده
چکیده
The main drawback of this method is that for typical path lengths possible in a crowded laboratory, very high frequencies are required to produce measurable phase shifts. This requires the use of specialized and expensive oscilloscopes to display the waveforms. The system used here, however, uses a mixing technique which allows the phase shift between high frequency signals to be observed on a standard laboratory oscilloscope.
منابع مشابه
An Optical Measurement System to Measure Velocity and Provide Shock Wave Pressure Diagrams
This paper introduces an optical measurement system for shock wave characteristics. The system works by mountinga metal plate attached to spring mounts against the shock wavefront. This set is sealed and can plot the shock wave pressure diagram by measuring plate's displacement, radiation and changing the reflection of light during shock wave conflict, and converting these optical data to volta...
متن کاملSimultaneous measurement of water flow velocity with fluorescent and speckle imaging technique
The average velocity of water flow has been simultaneously measured with fluorescent and speckle imaging methods. The measured velocities with two methods are in good agreement with each other and it confirms that the speckle imaging method can be used as a confident method to measure the velocity of water flow in a dry leaf. Also the velocity of water flow through thick and thin xylems of a le...
متن کاملDetermination of BKW Equation of State Parameters via Measurement of the Detonation Velocity in Condensed Explosives
An optical system has been redesigned and used to measure detonation velocity as a function of condensed explosive density for RDX, HMX, PETN. These measurements are then used to determine and fine tune parameters appearing in the BKW (Beker-Kistiakowsky-Wilson) equation of state for gases at extremely high pressures. Steady state form of conservation equations along with the BKW state equation...
متن کاملDetermination of BKW Equation of State Parameters via Measurement of the Detonation Velocity in Condensed Explosives
An optical system has been redesigned and used to measure detonation velocity as a function of condensed explosive density for RDX, HMX, PETN. These measurements are then used to determine and fine tune parameters appearing in the BKW (Beker-Kistiakowsky-Wilson) equation of state for gases at extremely high pressures. Steady state form of conservation equations along with the BKW state equation...
متن کاملPreparation and Characterization of CoMn/TiO2 Catalysts for Production of Light Olefins
A series of x(Co, Mn)/TiO2 catalysts (x=2–12wt.%) containing 25%Co and 75%Mn were prepared by the co-impregnation method. All prepared catalysts have been tested in Fischer-Tropsch synthesis for production of C2-C4 olefins. It was found that the catalyst containing 8wt.%(Co,Mn)/TiO2 is an optimal catalyst for production of C...
متن کاملWater Velocity Measurements in Open Channels Using Volumetric Current Meter (VCM)
An innovative Volumetric Current Meter (VCM) was designed in order to allow quick velocity measurements in open channels. At first, the coefficient of velocity (Cv) of the device was determined through calibration under different water velocities in the laboratory. The measurement performance was verified by measurements performed in similar flows in irrigation channels using an ordinary curren...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
عنوان ژورنال:
دوره شماره
صفحات -
تاریخ انتشار 2008